Part Names - American Dynamics illustra 400 ADCi400-B021 Quick Setup Manual

1. Part Names

1.1 The Component Parts ( the internal view )
You can dismantle the bullet IP camera to look at its different parts. Figure 1.1 displays the internal component
items making up the IP Bullet camera.
FRONT CASE
1.2 Camera with bracket ( the external view )
Figure 1.2 displays the camera's exterior, with the bracket screwed in and fixed to it. The bracket enables you to
easily mount the camera on a wall, turned to the angle you want.
NOTE: Use the 2 screws to screw the sun shield (above) into the 2
extreme holes indicated in the bullet camera (below) to get an
unobstructed viewing angle.
4
SUN SHIELD
SD PCB
LENS FAN
POWER PCB
SENSOR PCB
PCB PLATE
IR PCB
Figure 1.1 The Internal View
Figure 1.2 The External View
SCREWS
REAR CASE
MIDDLE CASE
WATERPROOF RUBBER
Quick Setup Guide