Advertisement
Http://www.fiberdyne.
cable. It will automatically detect the type of cable and link the connection.
· Link Fault Pass-Through: When cable in one end is OUT (disconnected/damaged/at fault), it will inform the
other end by turning OFF the remote end's link LEDs.
Cable Connection of FHC 10/100 Series Media Converters
Port type
10/100BASE-T Cat.3.4.5 UTP. RJ-45
100BASE-FX
Multi-mode Fiber of 62.5/125u
100BASE-FX
Single-mode Fiber of
10/125µm)
LED Indication
Please refer to the following table for LED indication of FHC 10/100-Series (External power)
Status
LED
FEF
Steady
Off
Steady
Off
SPD
Flashing
Off
FXLink/Act
Steady
Flash
PWR
Steady
TXLink/Act
Steady
Flash
FDX
Steady
Off
127 Business Park Drive
Frankfort, NY 13340 USA
TEL: (800) 894-9694 FAX: (315) 895-8436
Http://www.fiberdyne.com
com
Cable Type
Indication
Lit when local FX port receive signal from remote
port
NO Receiving
When TP data transmission speed is 100M
When TP data transmission speed is 10M
Collision occurred
Connection in half-duplex mode
Lit When fiber cable connection with remote
device is good
FX data exchange
The power is on
Lit When UTP cable connection with remote
device is good
TP data exchange
Connection in full duplex mode
Connection in half-duplex mode
FHC 10/100 Series Media Converter
100 meters
2km
1310nm
(9 or
20~100km
Max. Length
Version 1.0 July 2015
Page 2
Advertisement
