Related Manuals for MLB CH-Series
Summary of Contents for MLB CH-Series
- Page 1 HAZE MACHINE (WATER BASE ) USER MANUAL Please read over this manual before operation the machine...
-
Page 2: Table Of Contents
4.2 STORAGE AND A POINT FOR ATTENTION OF THE FLUID expected effect can reach up with the best mist.So the CH-Series 5. OPERATING THE DATA haze machine can fill up with all the room or stage and it can 5.1 PUTTING INTO OPERATION... -
Page 3: Safety Instructions
shake and keep in dry environment. 2. Safety instructions 9. Please do not work the machine if there is no liquid. A fog machine is not a toy！ Please note: People with health problems or problems of the 1. Never touch the nozzle when in operation. Danger of getting respiratory tract or with an inclination for allergies should avoid burnt. -
Page 4: Storage And A Point For Attention Of The Fluid
Liquid“ must be used.Use of other liquids will void the selected.（220V /60Hz, 110V /50Hz） manufacturer‘s warranty and can be dangerous to your health. Turn on power switch，Picture 1 appear on the display（refer (2) The Haze Liquid is 4bottles in a carton, 5liter per bottle. You Picture 1），then Picture 2 appear,（refer Picture 2），after one can buy from the local dealer. - Page 5 Picture 1 Adjust the output Picture 3. Smoke discharge time （Picture 3）. Press FUNC three times continuously，appear (Picture 1). Press FUNC one time, appear Picture 1, it means adjust the output, press UP and DOWN, it can adjust 1%~100% Picture 3, it means adjust the smoke discharge time, press UP output, press VOLUM, it can jet immediately.
-
Page 6: Dmx Control
and picture 3,it mean the machine will be worked as the setup of picture 2、 3、 4 and 5. Press the “TIMER” again,return to the main menu. 5.23 VOLUM Key-press Press “VOLUM”,the machine start to working, show the picture 1 spray time. -
Page 7: Care And Maintenance
P OW oil-way R U N button to reset, the pump will work 40 seconds until the LCD panel display interface for Picture 3, haze machine work normally. If the tank still have liquid inside but the machine show “ Out FUNC DOWN Order”, please check the liquid tube and fast connector of bottle... -
Page 8: Trouble-Shooting
Cause: Connection from the machine to the console is faulty. Power 900W 1200W 1200W · Check whether the plug is plugged in correctly · Check whether the cable is defective Heat up time 5Minutes 2-3Minutes · Check whether the DMX start address is adjusted correctly Output 3500cu.ft/min 5000cu.ft/min... - Page 9 ※ Also non compliance with the instructions in this manual or mistakes by incorrect handling/treating of the machine will lead to a loss of guarantee and also any faults and damages caused by undue force. ※ The customer loses all rights for guarantee services, if any repairs or adjustments are done to the units by unauthorized persons and/or if spare parts are used which are nor approved by 3.
Need help?
Do you have a question about the CH-Series and is the answer not in the manual?
Questions and answers