Attempt no internal repairs or adjustments not specifically detailed in this operating manual. Refer any readjustments, modifications, and/or repairs to Stryker Endoscopy or its authorized representatives. Pay close attention to the care and cleaning instructions in this manual. Failure to follow these instructions may result in product damage.
Product Description and Intended Use The Crossfire™ Footswitch is a foot-operated remote control used in conjuction with the Crossfire Integrated Arthroscopy system. It enables the user to activate and control the powered shaver handpiece and radio frequency (RF) electrosurgical probe. System Overview The footswitch is part of the Crossfire™...
Page 7
1. Crossfire™ Console • Acts as a connection hub for the various components of the Crossfire™ system • Powers a motorized shaver handpiece for the mechanical cutting and debridement of bone and soft tissue • Generates bipolar radio frequency (RF) energy for the electrosurgical cutting and coagulation of tissue • Provides a central user interface for operating the Crossfire™ system 2. Disposable RF probe Enables RF cutting and coagulation 3.
Carefully unpack the Crossfire™ Footswitch and inspect each of the following components. Report any damaged components to Stryker. Crossfire™ Footswitch (0475-000-100) User guide Compatible Accessories The Crossfire™ Footswitch is compatible with the following accessories: 0475-000-000 Crossfire™ Console Note: Crossfire footswitches are only compatible with Stryker systems and handpieces. EN-6...
The RF and shaver handpieces can be controlled by the Crossfire™ footswitch. The default footswitch controls are shown below. To customize button assignments, contact your Stryker representative. Note: To keep the footswitch clean during use, Stryker recommends using disposable bags (P/N 0277-500-100). Contact your local Stryker representative for ordering information.
Page 11
Default RF Controls Button Function (controls are the same for defaults 1, 2, and 3) Decrease Cut Level Select Handpiece: RF or Shaver Increase Cut Level Coag EN-9...
Page 12
Default Shaver Controls Button Function Default 1 Default 2 Default 3 Select Mode: Select Mode: Oscillate or Oscillate or Forward/Reverse Forward/Reverse Select Handpiece: Select Handpiece: Select Handpiece: RF or Shaver RF or Shaver RF or Shaver Select Direction: Select Speed: Select Speed: Forward or Reverse High or Low...
Cleaning and Maintenance Warning To minimize the risk of infection, clean the footswitch prior to the first use and every use thereafter. Use only non-abrasive cleaning agents. Do not disassemble, sterilize, or immerse the Crossfire™ Footswitch as this can damage the device. Cleaning Disconnect the footswitch from the console.
Symbols and Definitions This device and its labeling contain symbols that provide important information for the safe and proper use of the device. These symbols are defined below. Warning Symbols Consult instructions for use. Indicates risks to the safety of the patient or user.
Page 16
Protected against the Footswitch effects of temporary immersion in water. COAG This product contains electrical waste or electronic equipment. It must not be disposed of as unsorted municipal waste and must be collected separately. EN-14...
Page 20
Stryker Endoscopy 5900 Optical Court San Jose, CA 95138 USA 1-800-624-4422 U.S. Patents: www.stryker.com/patents 2016/02...