Advertisement
Quick Links
Advertisement
Summary of Contents for Rave 12’ Saturn
- Page 1 12’ Saturn™ Owner’s Manual Water Sports Equipment...
- Page 2 Keep away from fire and other heat sources. Keep out of direct • sunlight when not in use. Before using, RAVE recommends that you check local laws and • regulations and also, local water conditions for dangerous conditions.
- Page 3 WARNING! DO NOT OVER-INFLATE!! Product should not be firm! There should be a depression when pushed on with your hand. Please Note: Keep in mind the temperature of the air going into the product and the outside air. If your inflator is hot and sending warm air into the product, when it cools, it will seem like your Product is losing air.
- Page 4 12’ Saturn PARTS: 1 – Saturn 1 - Repair Kit consisting of: 4 oz of Glue, 2 – 8” square, patch of each in White and Blue POSITION: Make sure water depth is a minimum of 8 feet deep. There should also be a minimum of 16 feet clearance all around the unit.
- Page 5 SET UP AND SUPERVISION MUST BE DONE BY A MATURE AND KNOWLEDGEABLE ADULT! You can use the following devices to inflate the Product: Electric Inflator/Deflator (household current). RAVE recommends the • High Speed Inflator/Deflator, item #01083. CAUTION: Use extreme care when using an electric inflator anywhere near water.
- Page 6 A special inflation adaptor is included with this product. If you are using the RAVE Sports High Speed Inflator (Item #01083), simply lock the adaptor onto the end of the inflation hose and insert into the valve body. Turn ¼ turn to lock in place.
- Page 7 01024) is available through RAVE Sports and does include this heavy duty shock cord. • Adjust length of anchor line so that it is approximately 1-2 ft. longer than the depth of the water. The RAVE Sports anchor connector shock...
- Page 8 cord will provide 2-3 ft. of stretch to absorb waves and any vertical motion. NOTE: More slack in the anchor line may improve anchor holding performance, but too much slack may allow the product to flip over in strong winds. For best results, maximize your anchor holding power via more weight or a different type of anchor and minimize your anchor line length.
-
Page 9: Maintenance
Maintenance is essential to increase the life of your product. Please follow all maintenance and repairs according to this manual. If you are unsure please contact your local dealer, service center or RAVE Sports directly. Inspect product regularly for potentially unsafe conditions, •... - Page 10 Clean your inflatable with mild soap and fresh water and check that the valves are clean and not damaged. RAVE recommends the use of U.V. protectant for prolonging the life of your inflatable. To remove algae and other hazards from the ocean, you can use a special cleaning agent from your local marina.
- Page 11 Please note: rodents, such as mice, chew on fabric, including inflatable material. As a precaution you can place moth balls or fabric softener sheets around the products during storage to deter them. REPAIRS All of the inflatable products include a repair kit. You can easily repair minor punctures and cuts and even anchor plates or handles.
- Page 12 TIP – Place glue on the dull side of the patch and to the shinny side of the unit. Then when you apply the patch it will match. TIP – Use a short brush (just cut the length off) as this digs into the material better to spread the glue.
- Page 13 WARNING • THIS IS NOT A LIFESAVING DEVICE! • ALWAYS USE A U.S. COAST GUARD APPROVED (PERSONAL FLOATATION DEVICE) VEST FOR CHILDREN AND ADULTS! • DO NOT LEAVE CHILDREN UNATTENDED WHILE IN USE! • THIS PRODUCT SHOULD ONLY BE USED UNDER MATURE AND KNOWLEDGEABLE ADULT SUPERVISION AT ALL TIMES! •...