Advertisement

INPUT: 120V AC 60Hz 8W. OUTPUT: 14.4V DC 440mA.
OWNER'S MANUAL
Please read and understand all precautions prior to use.
Thank you for choosing a premium New Bright product.
L370102856/JN284-16

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 614VR and is the answer not in the manual?

Questions and answers

Summary of Contents for New Bright 614VR

  • Page 1 INPUT: 120V AC 60Hz 8W. OUTPUT: 14.4V DC 440mA. OWNER’S MANUAL Please read and understand all precautions prior to use. Thank you for choosing a premium New Bright product. L370102856/JN284-16...
  • Page 2: Component Checklist

    CONTENTS Component Checklist (1) Radio Control Vehicle (1) VR Goggle Headset with Camera AA AA (1) Transmitter (2) “AA” Batteries (1) Battery Charger (1) 9.6V Lithium-Ion Battery Pack CAUTION! Do not recharge Battery Pack if it is hot or warm to the touch. Allow Battery Pack to cool before recharging.
  • Page 3: Vehicle Battery

    VEHICLE BATTERY Charging IMPORTANT! The included 9.6V Lithium Ion battery pack is only PARTIALLY CHARGED prior to shipment and it is recommended the battery be fully charged before rst use. Charging Status Light Battery Charger Push and Hold Button To Remove 9.6V Battery Pack 1.
  • Page 4: Battery Installation

    TRANSMITTER Battery Installation 1. Flip smart phone holder up to reveal battery compartment. 2. Press and slide in the direction of the arrow open battery compartment cover. 3. Insert 2 “AA” size batteries. Make sure the positive (+) and negative (–) markings on the batteries match the markings inside the Battery Compartment.
  • Page 5 VEHICLE Battery Installation Locate and align arrow on battery pack with arrow inside battery compartment. Place battery pack in battery compartment and slide battery forward in direction of arrow. Once in place, turn locking tab to keep battery pack secure. * If battery pack is not completely in place locking tab will not fully turn.
  • Page 6: Camera & App

    This is normal. Connecting to the camera’s WiFi will disrupt internet service to your phone. To resume internet service, disconnect from the camera’s WiFi. 5. Launch the New Bright DashCam App on your smart device and select “Start”. (If a proper connection has not been made, you will be prompted to repeat steps 1-4).
  • Page 7: Camera Tilt

    CAMERA & APP Camera Tilt To adjust the angle of the camera, follow the instructions below. 1. Using a nger, gently pull back on windshield to reveal camera housing. 2. Camera tilt can be adjusted slightly. For a better viewing angle, push up or down on the camera, being careful not to touch the lens.
  • Page 8: Control Map

    TRANSMITTER Control Map Smart Phone Holder Camera Camera Forward/Reverse Left/Right Drive Steering Syncing This transmitter is equipped with 2.4GHz technology which allows up to 6 vehicles to be raced at the same time. Once vehicle and transmitter batteries have been correctly installed and vehicle ON/OFF Switch is in the ON position, the transmitter will automatically sync with the vehicle.
  • Page 9: Using The Transmitter

    TRANSMITTER Using the Transmitter Forward/Reverse Drive Push left joystick forward for forward driving. Release to stop. Pull left joystick backwards for driving in reverse. Left/Right Steering Push right joystick to the left for left turning. Release to stop. Push right joystick to the right for right turning. Release to stop. Camera OFF Press once to turn Camera OFF.
  • Page 10 VR HEADSET Inserting Phone into Goggles IMPORTANT! Read and understand all instructions and precautions before using the Goggles. The DashCam video will not appear on your smart device unless free DashCam App is installed and WiFi camera has been properly set up. For app download instructions and camera set-up, please refer to Section 5 of this manual.
  • Page 11: Wearing The Headset

    VR HEADSET Wearing the Headset IMPORTANT! Read and understand all instructions and precautions before using the Goggles. 1. Stretch the eleastic straps over your head while you position the VR Goggle headset opening over your eyes. 2. Hold the headset in position. Headset should sit level on your head. If headset is too low on the bridge of the nose, adjust the top strap by pulling the buckle towards the back of your head.
  • Page 12: Precautions & Care

    CAUTIONS Precautions & Care When using the VR Goggles, please be aware of and follow all precautions. 1. To reduce the chance of eye strain, eye fatigue or eye pain, use of the Goggles for extended periods of time should be avoided. 2.
  • Page 13: Troubleshooting

    SUPPORT Troubleshooting Problem - Vehicle does not move or moves slowly. - Has the Battery Pack been installed in the vehicle? - Has the rechargeable Battery Pack been fully charged? - Are the metal contact tabs touching, rusty or dirty in the battery compartment? - Make certain there are fresh alkaline batteries in the transmitter and that they have been installed in the correct position.
  • Page 14: Proper Use

    PROPER USE Precautions & Care...
  • Page 15 CAUTIONS Precautions & Care FCC CAUTION: Changes or modi cations not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
  • Page 16 (30) days from the date of purchase. In the event of such defect within the warranty period, New Bright will repair or replace the product at our sole discretion. This warranty does not cover damage resulting from unauthorized modi cations, accident, misuse or abuse.

Table of Contents