Table of Contents
Advertisement
Quick Links
SPECIFICATION
Model
Operate mode
Max. laminating width
Max. laminating thickness
Hot laminating temperature
Cold laminating temperature
Laminating speed
Recommended film
Temperature control
Heating method
Display
Driving motor
Power supply
Power consumption
Dimensions (L x W x H)
Weight
PDF 文件使用 "pdfFactory Pro" 试用版本创建
1100
Electric
1050 mm
5 mm
41-140℃
1-40℃
600-1600 mm/min
Up to 250 mic
8-bit microprocessor
Heating roll
LED
DC motor
AC100,110,220-240V/50,60Hz
2700W
1350×600×1170 mm
155 kg
14
www.fineprint.cn
ROLL LAMINATOR
OPERATION MANUAL
Please read this manual carefully before operation
Advertisement
Table of Contents
Related Manuals for Unitec LW-1100R
Summary of Contents for Unitec LW-1100R
- Page 1 SPECIFICATION ROLL LAMINATOR Model 1100 OPERATION MANUAL Operate mode Electric Max. laminating width 1050 mm Max. laminating thickness 5 mm Please read this manual carefully before operation Hot laminating temperature 41-140℃ Cold laminating temperature 1-40℃ Laminating speed 600-1600 mm/min Recommended film Up to 250 mic Temperature control 8-bit microprocessor...
-
Page 2: Table Of Contents
CONGRATULATIONS MAINTENANCE AND SERVICE roller, the film will be wrapped around the rollers. Thread the film in proper Thank you for purchasing and using our laminator. You have purchased the finest laminator available in its service class. It was position. designed and manufactured to provide you with the utmost in utility. -
Page 3: Safety Precautions
MAINTENANCE AND SERVICE SAFETY PRECAUTIONS Press FWD or REV button, the roller will run, cleans the roller. After cleaning, position the feed table and slide on the safety shield. WARNING Caution: if the film gets wrapped around the roller, press STOP button Please do not use broken, aging or self-made electrical wire and damaged supply cord. -
Page 4: Cleaning The Rubber Rollers
SAFETY PRECAUTIONS MAINTENANCE AND SERVICE COLD LAMINATING CAUTION 1. Press the SELECT button until the COLD lamp is light, load the cold film. This machine should be put at the dry and clean place, do not put it Caution: The adhesive side must face away from the roller. at the damp pl ace or near the exi t of cooli ng appliances. -
Page 5: Structure And Control Panel
OPERATION INSTRUCTIONS STRUCTURE AND CONTROL PANEL Step 6: Close the rollers with the knob on the right side of the laminator. Push the FWD button. The films will be fed into the machine. Check the status of Top supply roll Safety shield Core adapter Take-up bobbin... -
Page 6: Installation
INSTALLATION OPERATION INSTRUCTIONS Step 8: Push the FWD button. If the film and the card are in the nip (the point .Upon receipt of the laminator, inspect of box, the machine and all other where the top and bottom roller meet), the film and the threading card will start contents of the box for shipping damage. -
Page 7: Functions Of Digital Display, Control Panel And Emergency Stop
FUNCTIONS OF DIGITAL DISPLAY, OPERATION INSTRUCTIONS CONTROL PANEL AND EMERGENCY STOP 1. Digital display and Functions Remark: Usually the shiny side is the polyester side, it contact the roller. The dull side is coated with adhesive. For the matte film, the two sides have 1) Protecting function of temp sensor's open circuit and shot circuit minor difference, please especially be careful. -
Page 8: Preparation
FUNCTIONS OF DIGITAL DISPLAY, OPERATION INSTRUCTIONS CONTROL PANEL AND EMERGENCY STOP 2) Speed control PREPARATION 1. Connecting the power source 1) Checking the rated voltage on the machine, to insure it conform to the power A)These can be used for increasing or decreasing speed source.