HOW TO SET UP YOUR TRACTOR
INSTALL SEAT (See Fig. 2)
Adjust seat before tightening adjustment bolt.
•
Remove adjustment bolt, lock washer and fl at washer
se cur ing seat to cardboard packing and set aside for
as sem bly of seat to tractor.
•
Pivot seat upward and remove from the cardboard pack-
ing. Remove the cardboard packing and discard.
•
Place seat on seat pan so head of shoulder bolt is
positioned over large slotted hole in pan.
•
Push down on seat to engage shoulder bolt in slot and
pull seat towards rear of tractor.
•
Pivot seat and pan forward and assemble adjust-
ment bolt, lockwasher and fl at washer loosely. Do not
tighten
•
Lower seat into operating position and sit on seat.
•
Slide seat until a comfortable position is reached
which allows you to press clutch/brake pedal all the
way down.
•
Get off seat without moving its adjusted position.
•
Raise seat and tighten adjustment bolt securely.
SEAT PAN
FLAT WASHER
LOCK WASHER
ADJUSTMENT
BOLT
CHECK BATTERY (See Fig. 3)
•
Lift seat pan to raised position.
•
If this battery is put into service after month and year
indicated on label (label located between terminals)
charge battery for minimum of one hour at 6-10 amps.
(See "BATTERY" in MAINTENANCE section of this
manual for charging instructions).
ASSEMBLY
SEAT
SHOULDER
BOLT
02466
02465
FIG. 2
SEAT PAN
NOTE: You may now roll or drive your tractor off the skid.
Follow the ap pro pri ate instruction below to remove the
tractor from the skid
.
TO ROLL TRACTOR OFF SKID
er a tion section for location and function of
con trols)
•
Press lift lever plunger and raise attachment lift lever
to its highest po si tion.
•
Release parking brake by de press ing clutch/brake
ped al.
•
Place freewheel control in "trans mis sion dis en gaged
position" (See "TO TRANS PORT" in the Op er a tion
section of this manual).
•
Roll tractor forward off skid.
•
Remove banding holding the defl ector shield up against
tractor.
TO DRIVE TRAC TOR OFF SKID (See Op-
er a tion section for location and function of
con trols)
WARNING: Before start ing, read, un der stand and fol low
all in struc tions in the Op er a tion section of this man u al. Be
sure tractor is in a well-ventilated area. Be sure the area in
front of tractor is clear of other peo ple and objects.
•
Be sure all the above assembly steps have been com-
pleted.
•
Check engine oil level and fi ll fuel tank with gasoline.
•
Place freewheel control in "trans mis sion en gaged"
po si tion (see "TO TRANSPORT" in Op er a tion section
of this manual).
•
Sit on seat in operating position, depress clutch/brake
pedal and set the parking brake.
•
Place motion control lever in neutral (N) position.
•
Press lift lever plunger and raise attachment lift lever
to its highest position.
•
Start the engine. After engine has started, move throttle
control to idle position.
•
Release parking brake.
•
Slowly move the mo tion control lever for ward and slowly
drive tractor off skid.
•
Apply brake to stop trac tor, set park ing brake and place
motion con trol lever in neutral po si tion.
•
Turn ignition key to "STOP" position.
Continue with the in struc tions that follow.
7
LABEL
FIG. 3
(See Op-