Table of Contents
Advertisement
T373A & T373B User Manual
Example: 00FEF1 said that reading PGN 65265 "Cruise Control/Vehicle Speed"
parameter.
Click "Write" button to finish setting.
5.8.3 OBD parameters alarm setting
When OBD II protocol setting as J1939, device disable this function.
The device supports "Diagnostic Trouble Code (DTC) "alarm and 4 sorts of user-
defined alarm parameter setting. Configuration parameters included the reading
OBDII parameter, the judgment condition, monitoring value and duration of
four parameters.
If the temperature of configuration of "Engine Coolant Temperature" exceeded
105 degrees Celsius for 60 seconds, or configure "Fuel Level" less than 10%
lasted for more than 30 minutes, the device will alarm:
Login device via configuration software, select "OBDII" option as below showed:
Setting "OBDII Alarm" parameters:
Click "Write" button to finish setting.
5.9 Power Save Setting
5.9.1 Power Save Setting
User, SMS server and Web server upload cycle just will upload data and
message via setting parameters of "short interval" under the normal working
mode of the device. When the device under power save mode, the device will
use the configuration parameter of "Long interval "cycle upload message and
data. Therefore, the device will be in off status when it does not need to upload
data for a long time and it'll achieve power saving function. The device will be
automatic wake-up to upload data if it's needed. The device will be in the
power-saving status according to the configured condition of power save status.
Login device via configuration software, select "Service" option as below
showed:
Selected "device upload cycle" switch to "long interval" status.
---21---
Advertisement
Table of Contents
