Summary of Contents for Impressx XCITE BASIC
- Page 1 GmbH T: +49 211 936541-0 LTU-arena F: +49 211 936541-11 LTU-arena-Str. 1 info@impressx.com 40474 Düsseldorf www.impressx.com QUICK START ADMINISTRATOR´S GUIDE XCITE-SYSTEM english version...
-
Page 2: Table Of Contents
TABLE OF CONTENTS Component overview…………...…..…………………………………...………..3 Wiring plan..…………………………………………………………...……...…….3 xcite setup…………………………….……………………………………...……..5 xcite System-PC……………………………..………………….………………….5 Motion sensor setup…….…………………...……………………………………5 Speaker…….…………………………………………………………...…………...5 Start up the system.……………………………………………………………….6 Remote control…………………………………..………………..………………6 Keystone correction………………………………………………...…………….7 Sensor calibration………….……………………………………………...………7 Effect selection…………...……………………………………………………..8 EffectClient………………………………………………………………………….8 Save and transfer effects…………………………………………………………9 EffectProcessor……………………………………………………………….……9 projector distance………………………………………………………………..10 Montage-Kit……………………………………………………………………..10 xcite – interactive advertising... -
Page 3: Component Overview
COMPONENT OVERVIEW To operate a xcite BASIC -System the following components are needed: - xcite System-PC - motion sensor - switched plug-in adaptor 100 – 230 Volts - XLR cable - Video projector - VGA cable - speaker - audio cable for speaker (2 x XLR or minijack 3,5mm) - Page 4 Important: Power requirement has to be supplied astrally from the PC. This avoids the noise factor in the cable net. Lengths of VGA cable should not extend 40 metres. If the length is more then 40 metres, an amplifier has to be attached. At any rate, laying of VGA cables may not be combined with high voltage cables due to insufficient screening of the VGA cable.
-
Page 5: Xcite Setup
XCITE SETUP In this section the general setup of all components in a standard, single system environment with floor-projection is described. The wiring of all different components should be done as shown in the illustration above. XCITE SYSTEM-PC The main power switch is located on the back of the system. The system starts booting as soon as the switch is turned to “ON”... -
Page 6: Start Up The System
START UP THE SYSTEM Once all the parts are connected and the physical setup of the system is finished, you are ready to switch on the electricity. We highly recommend using one power circuit for all the equipment in order to reduce the possibility of ground loops and other noises disturbing the signals. -
Page 7: Keystone Correction
KEYSTONE CORRECTION Enter this menu item with the “OK” key. You can now adjust every corner of the projection to modify it exactly to your needs. Navigate with the arrow keys to the item you want to change (i.e. top-right corner) and then use the number keys as displayed below the menu to move the corner. -
Page 8: Effect Selection
EFFECT SELECTION In order to switch between different effects, you can use the “CH+” and “CH-“ key of the remote control. If you want to switch the EffectProcessor application into windowed or full screen mode, you can do so by using the key “R”... -
Page 9: Save And Transfer Effects
The size of the picture should be either 64 x 64, 128 x 128 or 256 x 256 – if you use other sizes, it may show distorted pictures because of a bug in older graphics drivers. The different settings of the effects are self-explanatory and can be easily learned by trying and experimenting with different settings. -
Page 10: Projector Distance
PROJECTOR DISTANCE MONTAGE-KIT xcite – interactive advertising...