Saorview DXD7025SVC User Manual page 8

Programme your remote control to
work with your TV
You can use your Saorview remote
control to control your TV as well as
your Saorview Connect box.
14
To automatically programme
the Saorview remote control,
follow these steps:
01 Turn on your TV with its
remote control.
02 On the Saorview remote
control, press and hold both
the RECORDINGS and the AD
key for 3 seconds to enter
programming mode. The red
LED on your Saorview remote
control will remain lit once in
programming mode.
03 For automatic programming,
press and release the main
Power key on the Saorview
remote control.
04 Press and release Channel up
and down key on the Saorview
remote control until the TV
switches off.
05 Once TV switches off, press
the OK key on the Saorview
remote control.
06 Press the EXIT key on the
Saorview remote control to
exit programming mode. Your
Saorview remote control will
now control your TV's volume
and power on/off functions.
To manually programme your
Saorview remote control,
follow these steps:
01 Press and hold both the
RECORDINGS and AD keys for 3
seconds to enter programming
mode. The red LED on your
Saorview remote control
will remain lit once in
programming mode.
02 Using the numeric keypad on
your Saorview remote control,
enter 4-digit code beginning
with 0 followed by product
code for your TV. A list of the
most common product codes
are listed in the section 'Remote
Control Programme Codes'.
The red LED on your Saorview
remote will blink for each key
press, and will show a longer
blink when the last digit is
entered. If programming is not
successful, the LED will flash
on and off eight times.
03 Check that the remote control
is programmed successfully by
pressing the TV button. Your TV
should power on and off, and
you should be able to adjust
your TV's volume with the
Saorview remote control.
To reset your remote control to its
default setting, do the following:
01 Press and hold both the
RECORDINGS and AD keys for 3
seconds to enter programming
mode. The red LED on your
Saorview remote control
will remain lit once in
programming mode.
02 Press HOME followed by the
RED button, and hold RED for 5
seconds (until LED blinks once).
15