Machine Operation - Kärcher BP20X Operating Instructions Manual

Machine Operation

For Indoor use only.
Pour utilisation à l'intérieur seulement.
When using the pad, always keep the machine
moving when in contact with the floor.
Lorsque vous utilisez le coussin protecteur,
gardez toujours la machine en mouvement
lorsqu'elle est en contact avec le sol.
High starting torque. Hold machine firmly with
both hands.
Couple de démarrage élevé. Tenez la machine
fermement à deux mains.
1. Ensure that the pad driver is in good shape.
Install or change pad if necessary.
2. Plug the machine into a wall outlet as described
in the grounding instructions.
3. Lower the handle by unlocking the adjustment
handle and moving the handle into position.
Relock the handle when it is in a comfortable
position.
Ensure that handle is locked in position before
starting machine.
Assurez-vous que la poignée est bloquée en
position avant de démarrer la machine.
4. Push the safety lock forward, unlocking the
switch levers.
86386990 Operators Manual - Floor Polisher
5. With the safety lock forward, squeeze one or both
of the switch levers, turning the machine on.
(These levers can be operated independently of
each other). The safety lock will not re-engage
until both levers are released.
6. To stop the machine, release the switch levers.
7. Do not let machine rest on pad. When finished
with the machine, return handle to the storage
position.
NOTE: The machine is equipped with a circuit
breaker to protect the motor in the event an
overload condition occurs. The circuit breaker is
located on the handle. Push the reset button to
restart the machine. If the breaker trips again,
correct the cause of overloading before proceeding.
Daily Maintenance
1. Inspect power cord for wear. To prevent electrical
shock replace cords with frayed or cracked insu-
lation immediately.
2. Place machine in the storage position.
3. Check pad condition. Change if soiled or torn.
Pad Driver/ Brush Installation
1. Lay machine back, exposing the under side.
2. Place pad driver on the motor lug and rotate
counter-clockwise until engaged. To remove, turn
clockwise.
Operations
15