Ethernet switch or hub during operation period. 2.3 LAN Configuration Connect the UTP cable to the LAN port of the AG1000-01. Power up AG1000-01. Wait until the LINK light starts to blink Go to “Control Panel”. Select “Network Connections”.
4.2 Triggering 2 AG1000-01 relay output If a 2nd AG1000-01 is installed far apart, AG1000-01 is able to trigger a relay output of the 2nd AG1000-01 using a SMS message. This section below will show a brief detail of the setup required.
Need help?
Do you have a question about the AG1000-01 and is the answer not in the manual?
Questions and answers