Front Control Panel Layout - Komet Aero 33 Owner's Manual

THANK YOU FOR PURCHASING THE KOMET
The Komet Aero is a straightforward and easy to operate amplifier. The goal of this manual
 
33
is to help you get acquainted
"
capable sounds.

FRONT CONTROL PANEL LAYOUT

1. Power Switch: engages the wall AC/ power to the amplifier.
2. Standby Switch: allow the amplifier to warm up for 60 seconds before engaging the
standby switch to the play position. This action will allow for all of the tubes to heat up
to the proper voltage required for operation and will help prolong their lifespan.
Pilot Light: illuminates when power switch is placed in the "
3.
light is a type #47
information).
4. Hi-Cut: this control allows shaping of the treble response in the power amp. For players
who prefer a darker tone, the only option with most amplifiers, is to roll down the treble
control. The treble control is passive
of gain, and "
muddy
the right balance by "darkening" or "brightening" the overall tone without changing the
basic EQ setting.
5. Presence Control: affects the highest frequencies in the output stage. It is normal to
hear a slight "
amplifier's particular circuit design.
6. Bass Control: controls the low end range bass frequencies.
7. Midrange Control: controls midrange frequencies.
8. Treble Control: controls high end range treble frequencies.
9. Volume Control: controls overall volume and gain of the amplifier.
10. Bright Switch: three way selector switch. Middle position is off, Down position
slightly bright, Up position
11. Input Jack: accepts standard ¼ inch plug. Input impedance is 1 Megohm.
Copyright 1999-2017, KometAmplification. Group, L.L.C. May not be reproduced in any form without express written consent from Komet Amplification.
with your Komet
"
light bulb.
(6.3 Volt)
" distortion. The Hi-Cut feature allows you to set the preamp EQ for
" sound when engaging the Presence control. This is due to this
scratchy
most bright.
-
AERO 33 AMPLIFIER

amplifier, and how to make use of its many

(left to right):
(See troubleshooting section for bulb replacement
(reduces a portion of the signal)
" position. The pilot
On
, so the result is a loss
-