Page 2
GARNET STATIC SHOCK BARK COLLAR Congratulations on buying this Our K9 Bark Collar, if for any reason you are not 100% completely satisfied with your Bark Collar, please contact me immediately so that I may help you.. Once you have been through the users guide and watched all the videos if you are unsure about anything, Please contact me at help@ourk9.com.
Page 3
WHAT THE BARK COLLAR ACTUALLY DOES WHEN YOUR DOG BARKS Our K9 Vibration Bark Collar can be adjusted to control the sensitivity of your dogs bark, according to the size of your dogs bark FEATURES BEEP SONIC SHOCK 1ST BARK 1.5 SEC...
Page 4
PUTTING THE COLLAR ON YOUR DOG: Switch the Collar off so the collar has been disabled. And adjust to the correct length, (there is a short video to help you if needed) the prongs MUST be against your dog's skin to work, and the Hole MUST be free of any Obstruction.…...
Page 5
THE PRONGS MUST BE FULLY EXTENDED WHEN ADJUSTING THE COLLAR. WHEN YOU HAVE FINISHED ADJUSTING THE COLLAR, ENSURE THAT THE PRONGS ARE FULLY EXTENDED. THE PRONGS ARE MADE FROM COPPER AND THEREFORE WILL NOT RUST BUT WILL TURN GREEN, THAT IS NORMAL FOR COPPER AND IT IS CALLED PATINA.
Page 6
Now leave the collar on your dog, Do Not switch the collar on…. Wait for 24 – 48 hours until your dog totally ignores the collar, initially they will scratch at it and just paw at it, when that completely stops we are ready to start the training. Remove the collar from your dog, you must be prepared to stay when you switch on the collar for the first time and start the training...
Page 7
Just hold it up with the back of the collar facing you, there is a small hole between the two prongs, just puff into the hole and the collar will make a Beep sound, do it again, and the collar will again make the another beep sound. Now do it a third time and the collar will make the beep sound again, and then deliver a small static charge.
Page 8
Now if the collar goes off when your doesn’t bark reduce the level down making the collar less sensitive. If however the collar does NOT go of when your dog barks you will need to make the collar more sensitive by increasing the sensitivity. PRESS PLAY TO WATCH VIDEO THE LAST AND MOST IMPORTANT STEP- IS SETTING UP THE CORRECTION LEVEL.
Page 9
Now we are going to start the Training, under no circumstances should you just put the collar on your dog and leave it them to figure out, your dog will get confused and extremely upset. You MUST teach them what you expect from them. Now please watch the training video PRESS PLAY TO WATCH VIDEO Remember every time your dog barks you give the command NO the collar will reinforce that...
Page 10
DO NOT JUST PUT THE COLLAR ON YOUR DOG AND EXPECT THEM TO UNDERSTAND WHAT IT IS SUPPOSED TO MEAN I WILL ADMIT SOME DOGS ARE SUPER SMART AND WILL UNDERSTAND ALMOST IMMEDIATELY, BUT WHAT IF YOUR DOG DOESN'T UNDERSTAND, HELP THEM UNDERSTAND, TEACH THEM…...
Page 11
5. The collar is not intended for use as a restraining collar. If you are using a leash, use it with a separate restraining type of collar. 6. Although the Anti-bark Collar's microprocessor is designed to differentiate your dog's Individual bark, the unit may occasionally be activated by other vibrations or movement.
Page 12
As your dog barks his throat will go in and out pushing air into the small hole at the back of the collar this is what will activate the bark collar. If the collar is not tight enough then the air will not get pushed in…. So why does it keep going off…...
Page 13
My Dog Barks But the Collar Does Not Activate... FOUR POSSIBLE REASONS Dead Battery - Check the Battery by Performing a Full Test. Refer Page 3 Sensitivity is set up Wrong. Adjust Sensitivity. Ref Page 5 Collar is too loose. Adjust Collar to fit correctly. Ref Page 4 Hole at the back of the Collar is Blocked.
Need help?
Do you have a question about the Bark Collar and is the answer not in the manual?
Questions and answers