General - Sony SRF-HM03V Service Manual

Tv / weather / fm stereo / am pll synthesized headphone radio
Hide thumbs Also See for SRF-HM03V:
Table of Contents

Advertisement

POWER ON/OFF
Light reflector (L)
This reflector
reflects car lights
at night for your
safety.
A
Setting the Clock
The clock time display of this unit is a 12-hour system.
When the battery is first installed, AM 12:00 flashes in the display.
1
Set POWER to OFF to turn off the power.
2
Hold down MEGA BASS/CLOCK for more than 2 seconds
until AM 12 starts flashing.
3
Press TUNE + or – to adjust the hour, then press MEGA BASS/
CLOCK.
If you hold down TUNE + or —, the digit changes rapidly.
AM 12:00 = midnight, PM 12:00 = noon.
4
Repeat step 3 above to adjust the minute.
: starts flashing and the clock starts operating.
To set the current time exactly to the second, adjust the minute and then press
MEGA BASS/CLOCK to synchronize with a time signal (such as the
telephone time signal).
Note
If you do not press TUNE + or —, or MEGA BASS/CLOCK within one minute,
the clock setting mode will be canceled.
SECTION 1

GENERAL

(Left)
Battery
compartment lid
TV/WB/FM SENS
DX/LOCAL
Light reflector (R)
MEGA BASS/CLOCK
Driver Unit
1
There is a tactile dot beside volume to show the
*
direction to turn up the volume.
2
The TUNE + button has a tactile dot.
*
Wearing the Headphone
Radio
(See fig A)
1
Wear the
right ear as illustrated.
2
Adjust the position of the driver units for a comfortable fit.
Changing AM Channel Step
The AM channel step differs depending on areas. The channel step of this unit is
factory-set to 10 kHz. Change the settings as shown below to be able to listen to
the radio.
Area
North and South American countries
Other countries
Note
When the AM channel step is changed, only the preset stations on the AM band
will be initialized.
1
Set POWER to OFF to turn off the power.
2
While holding down MODE, hold down TUNE + or – for more
than 5 seconds.
The channel step will change and 9 kHz (or 10 kHz) will flash for 3
seconds in the display.
If you proceed to step 2 again, the channel step changes again.
This section is extracted from
instruction manual.
(Right)
TUNE +*
VOL*
1
BAND
MODE
ENTER
Display
side driver unit in your left ear and the
Channel step
10 kHz
9 kHz
SRF-HM03V
2
/—
side in your
3

Advertisement

Table of Contents
loading

Table of Contents