Summary of Contents for Acme Tech B1045
- Page 1 ACME TECH Digital Proportional R/C System 3 Channel Systems Manual ACME TECH. (SHEN ZHEN) CO., LTD. TEL:86-755-2857 1661 FAX:86-755-2857 1053...
- Page 2 ACME TECH. (SHENZHEN) CO., LTD. INSTRUCTION MANUAL This device complies with part15 of the FCC Rules. Operation is subject to Caution: the following two conditions :(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
- Page 3 ACME TECH. (SHENZHEN) CO., LTD. INSTRUCTION MANUAL device should still work within a range of approximately 25-30 metres. •Before using the rechargeable batteries that are necessary for operating your remote control, you must charge them in accordance with the manufacturer’s specifications. If the power supply is too low due to empty batteries of empty rechargeable batteries, this lessens the range and you may loose control of your model.
- Page 4 ACME TECH. (SHENZHEN) CO., LTD. INSTRUCTION MANUAL 3、Function Description： 1)IC have a power supply switch(on/off),a trigger: control advance, backlash, back-draft; a direction controlling knob: control left or right steering; the third channel function key:CH3+,CH3-;The twelve function key: －, + ,CH, SEL, DT1－, DT1+, DT2－, DT2+, DT3－, DT3+, DT4－, DT4+。...
- Page 5 ACME TECH. (SHENZHEN) CO., LTD. INSTRUCTION MANUAL 4.Operation Instruction After Press the ON/OFF switch right , there are two setting way: (1) press the ‘SEL’ key and open the power switch, enter ‘System Function Setting’; Not press the ‘SEL’ key and open the power switch, then enter the Initial screen, after press the ‘SEL’...
- Page 6 ACME TECH. (SHENZHEN) CO., LTD. INSTRUCTION MANUAL Ordinary Function Setting M01-01 10.5V M01-01 100% 100% 100% RB 100% LF EPA-ST M01-01 M01-02 M01 - 10 EPA-TH EPA-3C EPA-3C SPD-TN SPD-RN REV-ST REV-TH REV-3C EXP-ST EXP-BK EXP-FW SBT-3C SBT-TH SBT-ST ABS-M...
- Page 7 ACME TECH. (SHENZHEN) CO., LTD. INSTRUCTION MANUAL (2) System Function Setting a. copy the model control data: On the Initial screen, press the ‘SEL’ key simultaneously then entry ‘MODEL COPY’: ’01-NN CPY’,press the ‘CH’ key from 01 to 10, and press ‘+/-’...
- Page 8 ACME TECH. (SHENZHEN) CO., LTD. INSTRUCTION MANUAL BK: Adjust the ‘BMX-RT’ OFF: Turn-off the function of the key At the system function initial screen, press ‘SEL’ many times then enter ‘FNC-DT’, then enter ‘Fnc DT1-ST’, press CH, enter ‘DT2-TH’,or ‘DT3-DR’ , or ‘DT4-AT’, or ‘DT1-ST’; press ‘+/-’ , enter ‘ST’ or ‘TH’ or ‘DR’...