Subaru LEGACY 2003 Service Manual page 19

2. READ CURRENT DATA
1) On the «Main Menu» display screen, select the {Each System Check} and press the «YES» key.
2) On the «System Selection Menu» display screen, select the {Brake Control System} and press the «YES»
key.
3) Press the «YES» key after displayed the information of ABS type.
4) On the «Brake Control Diagnosis» display screen, select the {Current Data Display & Save} and press the
«YES» key.
5) On the «Data Display Menu» display screen, select the {Data Display} and press the «YES» key.
6) Using the scroll key, move the display screen up or down until the desired data is shown.
• A list of the support data is shown in the following table.
Display screen
FR Wheel Speed
FL Wheel Speed
RR Wheel Speed
RL Wheel Speed
Stop Light Switch
Stop Light Switch
G sensor output Signal
Valve Relay Signal
Motor Relay Signal
ABS Signal to TCM
ABS Warning Lamp
Motor Relay Monitor
Valve Relay Monitor
CCM Signal
NOTE:
For detailed operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.
3. CLEAR MEMORY MODE
1) On the «Main Menu» display screen, select the
{2. Each System Check} and press the «YES» key.
2) On the «System Select Menu» display screen,
select {Brake System} and press the «YES» key.
3) Press the «YES» key after displayed the infor-
mation of ABS type.
4) On the «Brake Control Diagnosis» display
screen, select the {Clear Memory} and press the
«YES» key.
Display screen
Clear memory? Function of clearing trouble code.
5) When the "Done" and "turn ignition switch OFF"
are shown on the display screen, turn the Subaru
Select Monitor and ignition switch to OFF.
NOTE:
For detailed operation procedure, refer to the SUB-
ARU SELECT MONITOR OPERATION MANUAL.
SUBARU SELECT MONITOR
Contents to be monitored
Wheel speed detected by the Front Right ABS sensor is displayed
Wheel speed detected by the Front Left ABS sensor is displayed
Wheel speed detected by the Rear Right ABS sensor is displayed
Wheel speed detected by the Rear Left ABS sensor is displayed
Stop light switch signal
Stop light switch monitor voltage is displayed.
Refers to vehicle acceleration detecting by the analog G sensor. It
appears on the select monitor display in volts.
Valve Relay Signal
Motor Relay Signal
ABS operation signal from ABS control module to TCM
ON operation of the ABS warning light is displayed.
Operating condition of the motor relay is displayed.
Operating condition of the valve relay is displayed.
ABS operation signal from ABS control module to TCM
Contents to be monitored
4. ABS SEQUENCE CONROL
Display
Contents to be monitored
screen
Perform ABS sequence
ABS
control by operating valve
sequence
and pump motor sequen-
control
tially.
ABS-17
ABS (DIAGNOSTICS)
Unit of measure
km/h or MPH
km/h or MPH
km/h or MPH
km/h or MPH
ON or OFF
V
V
ON or OFF
ON or OFF
ON or OFF
ON or OFF
ON or OFF
ON or OFF
ON or OFF
Index No.
<Ref. to ABS-9,
ABS Sequence
Control.>