Removing And Reinstalling The Main Parts - Sharp JG545X(GY) Service Manual

TAPE MECHANISM SECTION
Perform steps 1, 2, 5, 6 and 7 of the disassembly method to
remove the tape mechanism. (See Page 3.)
How to remove the playback head
(See Fig. 4-l .)
1. Removethescrews(A1) x2pcs., to remove the playback head.
Note: After replacing the playback head and completing the
azimuth adjustment, be sure to apply screwlock.
How to remove the pinch roller
(See Fig. 4-l.)
it.
How to remove the main/motor belt
(See Fig. 4-2.)
1. Remove the motor belt (Cl) xl pc.
2. Remove the main belt (C2) x 1 pc.
How
to remove the motor
(See Fig. 4-2.)
2. Remove the screws (Dl) x 2 PCS., to remove the motor.
How to remove the flywheel
(See Figs. 4-2 and 4-3.)
1. Remove the main belt (C2) x 1 pc.
2. Remove the washers (Dl) x 2pcs.
3. Remove the stop washers (D2) x 2 PCS., with a small precision
screwdriver to extract flywheel from the capstan matal.
Note: When the stop washer is deformed or damaged, replace it
with a new one.
How to reinstall the parts
Install each part in the reverse order of the removal with care.
(Al) x 2
Playback
Figure 4-1
Flywheel
Figure 4-2
Figure 4-3
Flywheel