Advertisement
Quick Links
Advertisement
Summary of Contents for Elmo-Tech SBU2000
- Page 1 SBU2000 / 2Track base unit Installation and Operation Guide...
- Page 2 Information in this documentation is subject to change without notice and does not represent a commitment on part of Elmo-Tech Ltd. The software described in this document is subject to the license agreement that is included with the product, which specifies the permitted and prohibited uses of the product.
- Page 3 Table of Contents...
- Page 4 In order to install the Electronic Monitoring System, you will need to find the best location for the SBU2000 Monitoring Unit. The ideal location for the SBU2000 Monitoring Unit is as close as possible to the center of the house.
- Page 5 The SBU2000 Monitoring Unit should be placed on a flat horizontal surface, at least 3 feet off the ground and at least 1 foot away from the wall. The SBU2000 Monitoring Unit should be in an open area away from other electrical appliances, personal computers, laptops or metal objects.
- Page 6 5. After completing the initialisation tests successfully the SBU2000 Monitoring Unit beeps again and the left and right external LED indicators, located on the rear panel of the SBU2000 Monitoring Unit are turned on. This indicates that the SBU2000 Monitoring Unit is in a working state and has automatically switched to standby mode.
- Page 7 Warning: The Tracker unit’s battery must be fully charged. Verify the battery’s status by plugging the charger into the Tracker unit and removing it. The Tracker unit’s screen displays a power bar to indicate the charge level of the battery. b.
- Page 8 4. Place 2TRACK in SBU2000 Unit The SBU2000 unit device used to recharge the 2TRACK and transmit all GPS location information, violation information, and house arrest status. It also monitors the Ankle Bracelet when the 2TRACK is placed in the base unit (docked).
- Page 9 2. Once you have the strap attached, push the locking pin through the holes on the bracelet and into the strap until it locks into place 3. Make sure the locking pin is pushed far enough so that the top of the pin is flush with the bracelet case...
- Page 10 Downloading the Curfew Schedule Once the monitoring system has been installed, perform the following: 1. Verify that the right LED located on the rear panel of the SBU2000 Monitoring Unit is constantly on and not flashing. 2. Using a mobile phone, call the monitoring center personnel and ask them to...
-
Page 11: Fcc Notices
6. FCC Notices The SBU2000 complies with Part 15 of the FCC Rules. Operation is subject to the following conditions: 1) This device may not cause harmful interference and 2) This device must accept any interference received, including interference that may cause undesired operation. - Page 12 The Telephone Company may make changes in its facilities, equipment, operations or procedures that could affect the operation of the equipment. If this happens the telephone company will provide advance notice in order for you to make necessary modifications to maintain uninterrupted service. If trouble is experienced with the Smart Base Unit, model: SBU x000yyy, for repair or warranty information please contact: Pro Tech Monitoring, lnc., 1838 Gunn Highway, Odessa, FL 33556, Phone 888.67.SMART, FAX...
Need help?
Do you have a question about the SBU2000 and is the answer not in the manual?
Questions and answers