Precision PWS 5-3 Owner's Manual

Automatic countertop water distiller

Advertisement

Quick Links

OWNER'S GUIDE
MODEL: PWS 5-3
AUTOMATIC COUNTERTOP
WATER DISTILLER
Part # 500028 – 120V
Manufactured By:
PRECISION DESIGN &
MANUFACTURING INC.
9024-100 Street
Westlock, Alberta, Canada
T7P 2L4
Email: info@precisioncanada.com
03/18/15
Part # 500029 – 240V
Series: 0015
IMPORTANT
Read through this owner's manual carefully
before using your new distiller. Pay close
attention
IMPORTANT FACTS.
properly and only for its intended use.
1
:
to
all
INSTRUCTIONS
Use
your distiller
and

Advertisement

Table of Contents
loading

Summary of Contents for Precision PWS 5-3

  • Page 1 OWNER’S GUIDE MODEL: PWS 5-3 AUTOMATIC COUNTERTOP WATER DISTILLER Part # 500028 – 120V Part # 500029 – 240V Series: 0015 Manufactured By: IMPORTANT PRECISION DESIGN & Read through this owner’s manual carefully MANUFACTURING INC. before using your new distiller. Pay close...
  • Page 2 This Page Left Intentionally Blank 03/18/15...
  • Page 3: Table Of Contents

    Water Distiller. We take pride in our product quality. This product has been carefully inspected to meet rigid factory quality standards. We are confident that, with reasonable care, the PWS 5-3 Water Distiller will provide you with years of reliable product performance. Model Name:...
  • Page 4: Warranty

    Year 15 - 5% Year 10 - Precision Design & Manufacturing Inc. is not responsible for or obligated to pay costs of removal, installation or any shipping charges in relation to the claimed warranty. Warranty is invalid if damage is caused by: product misuse, improper installation, signs of alteration, product neglect, shipping damage, mishandling, vandalism or act of God.
  • Page 5: Important Safety Precautions

    14. Do not use appliance for other than intended use. 15. Save these instructions. ASSEMBLY INSTRUCTIONS The PWS 5-3 Water Distiller has been shipped in one box that is comprised of the following: 1. Distillation Head 2. Storage Tank 3. Owner’s Guide 4.
  • Page 6: Principal Components

    PWS 5-3 PRINCIPAL COMPONENTS 1. Cooling Coil 2. Gas Vent 3. Lid Knob 4. Boiler Tank Lid 5. Boiler Tank Lid Gasket 6. Boiler Tank 7. Adapter 8. Drain Valve 9. Com pression Nut 10. Im purities Drain Tube 11. Heating Elem ent 12.
  • Page 7: Storage Tank Faucet

    STEP 1 STORAGE TANK FAUCET Remove the hex nut from the threaded faucet end. Push the gasket tightly over the threads up against the faucet. Insert threaded faucet end with gasket through the opening found at the bottom portion of the water storage tank. Take the hex nut in one hand and through the large opening on top of the storage tank insert hand to find the faucet end.
  • Page 8: Set Up

    STEP 3 SET UP Place the distiller head on the storage tank. Place the head over the feet on the top of the storage tank and position the back of the distiller over the storage tank float post. Be sure that the sight gauge faucet and the distiller control switches are facing the same direction.
  • Page 9: Switches

    STEP 6 SWITCHES There are three switches on your PWS 5-3 water distiller. The right switch is your power and left is the cooling fan. By pressing the switches down they will be in the off position. The water switch is located at the rear left side of the distiller.
  • Page 10: Charcoal Filter

    STEP 7 CHARCOAL FILTER Rinse the new charcoal filter cup a few times with distilled water to remove any charcoal dust prior to placing into the storage tank. Remove the distiller head from the storage tank to gain access to the charcoal filter cup.
  • Page 11: Lets Make Water

    MANUAL FILL OPERATION Turn the water fill off at the rear of the distiller. Then your PWS 5-3 is a manual fill system, requiring you to fill the boiling tank each time. Please note that there is a water gauge pin present in the boiling tank.
  • Page 12: Trouble Shooting

    4. Requires new charcoal filter cup. Contact any Precision Water System Service Center to correct any problems with your distiller that is not covered in this guide. Your may contact the factory at the address on the front cover of this Owner’s Guide for a Service Center in your area.
  • Page 13: Maintenance

    MAINTENANCE CLEANING THE BOILING TANK Drain the boiling tank following each 10 gallons of water distilled. Simply place a bucket under the impurities drain tube and turn the valve to release impurities. Every two weeks take a good look inside the boiling tank. If there is a build up of scale on the sides of the boiling tank, then use the descaler provided to clean the tank as follows: 1.
  • Page 14 This Page Left Intentionally Blank 03/18/15...
  • Page 15: Warranty Registration

    IMPORTANT! PRECISION DESIGN & MFG. INC. IMPORTANT! Thank you for purchasing this fine Precision Water Systems Water Distiller. Please complete the information below and return it within the next ten days so we may register your purchase. 1. Mr. 2. Mrs.

Table of Contents