Summary of Contents for Goldline AQL-SPASIDE-RF
- Page 1 Aqua Logic Aqua Logic ® Aqua Logic Aqua Logic Aqua Logic Spa-side Remote Installation/Operation Manual for model AQL-SPASIDE-RF LDLINE CONTROLS INC. North Kingstown, RI USA www.goldlinecontrols.com...
- Page 2 (the “main” rev should be r1.10 or higher). If the software revision level is less than r1.10 contact the Goldline Technical Service Dept. from Monday through Friday, 8AM to 8PM Eastern at 888-921-7665 for infor- mation on upgrades.
- Page 3 Operation The spa-side remote communicates with the base receiver on the Aqua Logic control unit using RF (radio frequency) technology. When you push a button on the spa-side remote, it sends a command and flashes the LED indicator once. After the spa-side remote receives a confirmation from the Aqua Logic base the receiver, the LED indi- cator on the spa-side remote flashes a 2 time.
-
Page 4: Battery Replacement
Replace the 2 AAA batteries. Alkaline batteries are recommended for maxi- mum life. If you observe any corrosion or water damage, contact the Goldline Technical Service Dept Monday through Friday, 8AM to 8PM at 888-921-7665 for assistance. -
Page 5: Troubleshooting
Check that the 4 wire cable from the base receiver is plugged into the “wire- less" connector on the main printed circuit board. If this connector is already plugged in (for more than 30 seconds), then call Goldline Technical Service for assistance. - Page 6 Goldline Controls will, at its option, either repair or replace the defective product and return it freight prepaid. For years 4 and 5, Goldline, at its option, either repair or replace the defective product and will charge 60% of the current list price for such repairs or replacements, plus shipping charges.
- Page 7 QUENTIAL OR INCIDENTAL DAMAGES OF ANY NATURE WHATSOEVER. No wholesaler, agent, dealer, contractor, or other person is authorized to give any warranty on behalf of Goldline Controls, Inc. This warranty is void if the product has been altered in any way after leaving the factory.
- Page 8 FCC Statement (Compliance Statement, Part 15.19): This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Need help?
Do you have a question about the AQL-SPASIDE-RF and is the answer not in the manual?
Questions and answers