Summary of Contents for GoECOlife SED-10R
-
Page 1: User Guide
Remote USER GUIDE for #SED-10R Customer Support: 866-377-4771 support@goecolife.com... -
Page 3: Table Of Contents
Table of Contents Product Specifications & Diagram ......2 Caution ..............3 Technical Information ...........4-5 Introduction .............6 Set Up Link ...............7 Operation .............8-9 Mounting Holster ..........10 Frequetly Asked Questions (FAQs) ....11-13 Limited Product & Connected Equipment Warranty ..... 14-16... -
Page 4: Product Specifications & Diagram
Product Specification SEED Remote & Holster ™ Power ON/ LINK Indicator Light Power ON Button Power OFF Button LINK to Remote Button Mountable Holster • Remote Range ......65 ft/20 m • Remote Frequency ......433MHz • Batteries (not included) .....Size AAA (2) •... -
Page 5: Caution
caution • FOR INDOOR USE. DO NOT USE THIS PRODUCT NEAR WET AREAS SUCH AS SINKS AND NEAR AQUARIUMS. -
Page 6: Technical Information
FCC Information • FCC ID: YF3MC-SED10R01 • This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. - Page 7 FCC Information (cont’d) the user is encouraged to try to correct the interference by one or more of the following measures: 1. Reorient or relocate the receiving antenna. 2. Increase the separation between the equipment and receiver. 3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-
Page 8: Introduction
Introduction Thank you for purchasing the SEED™ Remote. This device helps eliminate phantom power consumption by electrical devices which are powered OFF. PLEASE READ THROUGH THIS USER GUIDE CAREFULLY to ensure proper set up and operation of the SEED™ Remote. PLanninG •... -
Page 9: Set Up Link
Set Up Link A. Press the LINK button on the SEED™ device. The indicator light will flash a blue light. B. Then press the LINK button on the remote. The indicator light will show a blue light for about a second. -
Page 10: Operation
Operation PoWERinG on tHE SEED™ DEVicE Before powering on the electrical devices connected to the SEED™, you must POWER ON the SEED™. To POWER ON the SEED™ with the SEED™ Remote, press the ON button on the remote. - Page 11 Operation PoWERinG oFF tHE SEED™ DEVicE There is only one way to manually power OFF a SEED™ device: • Press the OFF button for 3 seconds on the remote. NOTE: The SEED™ device is designed to automatically power OFF 5 minutes after all connected electrical devices have been turned off.
-
Page 12: Mounting Holster
Mounting the Holster MountinG tHE SEED REMotE HoLStER On the back of the remote holster, expose the cover of the adhesive tape and attach vertically to either the wall or furniture. Place the remote holder in a location convenient for you to turn off your devices (i.e. -
Page 13: Frequetly Asked Questions (Faqs)
Frequently Asked Questions (FAQs) How does the SEED™ save energy? Electrical devices and appliances left plugged into outlets but turned OFF still draw electricity. This is known as “phantom load” or vampire energy consumption. Therefore, your electrical devices and appliances constantly draw and waste valuable energy from the moment you power them OFF till the moment you power them back... - Page 14 Frequently Asked Questions (FAQs) can i link an additional remote to the same SEED™? Yes. You can link 4 SEED™ Remotes to a single SEED™. can i link my remote to more than one SEED™? Yes. You can link your SEED™ remote to up to 99 SEED™...
- Page 15 Frequently Asked Questions (FAQs) What does “certified carbonFree®” mean? Your SEED™ is a carbon neutral product. It meets Carbonfund.org’s CarbonFree® Product Certification protocol which requires third-party life cycle assessment of the product’s carbon footprint, and carbon reductions in support of third-party validated renewable energy and reforestation projects.
-
Page 16: Limited Product
Limited Product Warranty Intek America, Inc. (the “Manufacturer”) warrants to the original purchaser of the SEED™ Remote for one (1) year after the date of purchase, that the SEED™ Remote shall be free of defects in design, assembly, material, or workmanship, and will repair or replace, at its option, any defective SEED™... - Page 17 Limited Product Warranty (cont’d) MANUFACTURER. THERE ARE NO OTHER WARRANTIES, EXPRESS OR IMPLIED, EXCEPT AS REQUIRED BY LAW. IMPLIED WARRANTIES REQUIRED BY LAW INCLUDE THE IMPLIED WARRANTY OF CONDITION OF QUALITY, MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, AND SUCH IMPLIED WARRANTIES, IF ANY, ARE LIMITED IN DURATION TO THE TERM OF THIS WARRANTY.
- Page 18 Limited Product Warranty (cont’d) must take the following steps: • Contact: INTEK America, Inc. 18528 S. Dominguez Hills Drive Rancho Dominguez, CA 90220 Attn: Customer Support, or call 866-377-4771. All claims must be filed within 15 days from the date of the INCIDENT and must be accompanied by a receipt for the damaged equipment or the warranty is void.
-
Page 20: Customer Support
™ Customer Support: 866-377-4771 support@goecolife.com Copyright © 00 INTEK America, Inc. Rancho Dominguez, CA 00. ALL RIGHTS RESERVED.
Need help?
Do you have a question about the SED-10R and is the answer not in the manual?
Questions and answers