Advertisement
Quick Links
TO AVOID DAMAGE TO GEN II UNIT, READ IMPORTANT NOTE IN INSTALLATION
TO
DISPLAY
+12V WITH KEY ON
CABIN TEMP
SENSOR
VENT TEMP
SENSOR
FLOOR TEMP
SENSOR
mounting
stud
Pg. 1/6
DCC-2200 / DCC-2300
CLIMATE CONTROL MODULE
for Vintage Air Gen II Modules
INSTRUCTIONS BEFORE BEGINNING INSTALLATION!!!
AUTOMATIC CLIMATE CONTROL
to controller
shield wire
back of display
Figure 1: Wiring diagram
DCC-2200
EVAPORATOR PROBE
YELLOW
RED
+12V WITH KEY ON
+12 BATTERY
FUSED 30A
GREEN
RED
BLUE
WHITE
BLACK
COMPRESSOR
SAFETY
SWITCH
COMPRESSOR
CLUTCH
PINK
BLUE
GEN II
GREEN
MODULE
YELLOW
PINK
ORANGE
GREEN
CONTROL
YELLOW
MODULE
RED
DO NOT USE
FAN
FAN
MOTOR
MAN#650139
Advertisement
Summary of Contents for Dakota Digital DCC-2200
- Page 1 DCC-2200 / DCC-2300 CLIMATE CONTROL MODULE for Vintage Air Gen II Modules TO AVOID DAMAGE TO GEN II UNIT, READ IMPORTANT NOTE IN INSTALLATION INSTRUCTIONS BEFORE BEGINNING INSTALLATION!!! PINK BLUE DCC-2200 GEN II DISPLAY AUTOMATIC CLIMATE CONTROL GREEN MODULE YELLOW...
- Page 2 CLIMATE CONTROL DISPLAY 11. Set temperature 1. Fan speed indicator 10. Temperature scale 9. Temperature up 2. Fan speed up ^ FAN A/C FLOOR 8. Temperature down 3. Fan speed down 7. Duct mode indicator 4. A/C mode indicator 5. A/C mode select 6.
-
Page 3: Installation
INSTALLATION The DCC-2200/2300 is designed to work with the GEN II module from Vintage Air. See the Vintage Air manual for the installation instructions for the GEN II module. If the GEN II module is not yet installed, it may be easier to put the temperature sensors into the module before installing it into the vehicle. - Page 4 Figure 3: Drilling the hole for the vent sensor in a GEN II Compac unit. Note Figure 4: GEN II Compac unit with input, vent, and the hose on the drill bit to prevent drilling too deep. floor sensors installed. STEP 1 VENT SENSOR INSTALLATION: Using a 3/8”...
-
Page 5: Troubleshooting
These are the wires that would typically go to the mode switch on the GEN II control panel. If the GEN II module is not equipped with defrost, leave the green wire unconnected. Plug the connector for the heat control into the 3 pin connector labeled “HEAT” on the DCC-2200 controller. STEP 7 TEMP SENSOR WIRING: Connect the temp sensors to the controller as shown in the wiring diagram. -
Page 6: Service And Repair
Any action for breach of any warranty hereunder, including any implied warranty of merchantability, must be brought within a period of 24 months from date of original purchase. No person or representative is authorized to assume, for Dakota Digital, any liability other than expressed herein in connection with the sale of this product.