Advertisement
1. Fan speed
indicator
2. Fan speed up
3. Fan speed down
4. A/C mode indicator
5. A/C mode select
1. Fan speed indicator
This portion of the display indicates the currently selected fan speed. When the climate control unit is off it will
read as "FAN OFF". In manual speed selection mode there are 7 speeds depicted by an increasing number of
large blocks. When all 7 large blocks are showing, the fan is at the highest speed. The next upper fan button
press will then place the fan into auto mode, depicted "FAN AUTO". Here the fan speed is automatically set as
needed.
2. Fan speed up
Pressing the fan speed up button will increase the speed of the fan. If the unit is off, pressing this button turns the
unit on. If pressed when the fan is at the fastest setting, the fan will be put in auto mode.
3. Fan speed down
Pressing this button will remove the fan from auto operation and decrease fan speed with each press. When fan
is at lowest setting, pressing fan speed down button will turn the unit off.
4. A/C mode indicator
This indicator displays if the air conditioner is turned on or off. If the air conditioner is on, "A/C" is displayed.
"ECON" is displayed when it is off.
5. A/C mode select
Pressing this button toggles the air conditioning between on and off. Hold this button while turning the key on to
get to the setup menu.
6. Duct mode select
Pressing this button moves through the different modes of the Gen II module ductwork. The order of modes is
FLOOR
BiLev
DEF
VENT
7. Duct mode indicator
This indicator displays the current duct mode. These modes are listed and described above.
8. Temperature down
Pressing this button decreases the set cabin temperature. The minimum controlled temperature is 60ºF or 15ºC.
Pressing the temperature down button again at the minimum controlled temperature changes the temperature to
55ºF or 13ºC. At this setting, the temperature is no longer controlled and the air conditioning is at maximum. This
is useful for quickly cooling a hot cabin.
9. Temperature up
Pressing this button increases the set cabin temperature. The maximum controlled temperature is 85ºF or 29ºC.
Pressing the temperature up button again at the maximum controlled temperature changes the temperature to
90ºF or 32ºC. At this setting, the temperature is no longer controlled and the heat is on maximum. This is useful
for rapidly heating the cabin.
10. Temperature scale
This signifies the current temperature scale in use. To change the temperature scale, see setup instructions.
11. Set temperature
This displays the current set cabin temperature. This is the goal temperature the unit attempts to maintain.
Pg. 2/6
CLIMATE CONTROL DISPLAY
^ FAN
A/C FLOOR
air is blown out the floor vents of ductwork
air is blown out of the vents and onto the floor
air is blown onto windshield (May be disabled if duct has no defrost. See setup)
all air is blown out the vents
11. Set temperature
^
72
F
6. Duct mode select
10. Temperature scale
9. Temperature up
8. Temperature down
7. Duct mode indicator
MAN#650139
Advertisement
