Lanesense - If Equipped - Jeep 2017 RENEGADE Quick Reference Manual

Rear Cross Path
The Rear Cross Path (RCP) feature is intended
to aid the driver when backing out of parking
spaces where their vision of oncoming vehicles
may be blocked. Proceed slowly and cautiously
out of the parking space until the rear end of the
vehicle is exposed. The RCP system will then
have a clear view of the cross traffic and if an
oncoming vehicle is detected, alert the driver.
Mode Of Operation
Three selectable modes of operation are avail-
able in the Uconnect System. They are avail-
able through the Uconnect System.
Blind Spot Monitoring Fault Warnings
Sensor Blinded – In the case of a sensor
blinded:
• BSM Mirror Warning Lights are turned on
continuously.
• An instrument cluster message will display
"Blind Spot Monitoring Unavailable - Wipe
Rear Bumper Corners."
System Not Available – In the case of the
system being temporary unavailable:
• BSM Mirror Warning Lights are turned on
continuously.
• An instrument cluster message will display
"Blind Spot Monitoring Temporary Unavail-
able."
In the case of the system being completely
unavailable:
• A chime will turn on.
• An instrument cluster message will display
"Blind Spot Monitoring Unavailable - Ser-
vice Required."
For further information and applicable warnings
and cautions, please refer to your Owner's
Manual at www.jeep.com/en/owners/manuals.
LaneSense — If Equipped
The LaneSense system is operational at speeds
above 37 mph (60 km/h) and below 112 mph
(180 km/h). The LaneSense system uses a
forward looking camera to detect lane markings
and measure vehicle position within the lane
boundaries.
Turning LaneSense ON Or OFF
The default status of LaneSense is "OFF". The
LaneSense button is located on the switch
panel below the Uconnect display.
LaneSense Warning Message
The LaneSense system will indicate the current
lane drift condition through the instrument
cluster display. The instrument cluster display
will provide a visual warning depicting the un-
intentional lane departure.
When both lane markings are detected and the
driver unintentionally drifts out of the lane (no
turn signal applied), the LaneSense system
provides a haptic warning in the form of torque
applied to the steering wheel to prompt the
driver to remain within the lane boundaries.