Replacing The String; Preparing The Battery Pack For Recycling - Toro Power Plex 51482 Operator's Manual

Replacing the String

1. Remove the battery.
2. Remove the spool; refer to
(page 13).
Figure 16
1. Spool
2. Anchor slot
Note:
Remove any old string remaining on the
spool.
3. Each side of the spool accepts approximately
3.6 m (12 ft) of string. Use only 2 mm (0.08
inch) diameter monofilament string.
Note:
Do not use any other gauge or type of
string, as this could damage the trimmer.
4. Insert the string into the anchor slot in the upper
part of the spool
onto the spool in the direction shown by the
arrows on the spool.
5. Place the string in the slot on the upper spool
flange, leaving about 152 mm (6 inches)
extended beyond the slot.
Note:
Do not overfill. After winding the string,
there should be at least 6 mm (1/4 inch) between
the wound string and the outside edge of the
spool.
6. Replace the spool and the spool retainer; refer
to Replacing the Spool (page
Replacing the Spool
(Figure 16). Wind the string
13).
Storage
Important:
Store the tool, battery pack, and
charger only in temperatures that are within the
appropriate range; refer to
Important:
If you are storing the tool for a year or
longer, remove the battery pack from the tool and
charge the battery pack until 2 or 3 LED indicators
turn blue on the battery. Do not store a fully
charged or fully depleted battery. When ready to
use again, charge the battery pack until the left
indicator light turns green on the charger or all 4
LED indicators turn blue on the battery.
g203888
•
Disconnect the product from the power supply
(i.e., remove the plug from the power supply or the
battery pack) and check for damage after use.
•
Clean all foreign material from the product.
•
When not in use, store the tool, battery pack, and
battery charger out of the reach of children.
•
Keep the tool, battery pack, and battery charger
away from corrosive agents, such as garden
chemicals and de-icing salts.
•
To reduce the risk of serious personal injury, do
not store the battery pack outside or in vehicles.
•
Store the tool, battery pack, and battery charger
in an enclosed clean, dry area.
Preparing the Battery Pack
for Recycling
Important:
Upon removal, cover the terminals of
the battery pack with heavy-duty adhesive tape.
Do not attempt to destroy or disassemble the
battery pack or remove any of its components.
Recycle or properly dispose of lithium-ion battery
packs at a battery recycling facility.
14
Specifications (page 9).