Drive DeVilbiss AGF-6X2 Instruction Manual

Digital ems

Advertisement

Quick Links

AGF-6X2 Digital EMS

Instruction Manual

Drive DeVilbiss Healthcare
99 Seaview Boulevard
Port Washington, NY 11050
Tel: 877- 224-0946
www.drivemedical.com
REV 1.03.29.17

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the AGF-6X2 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Drive DeVilbiss AGF-6X2

  • Page 1: Instruction Manual

    AGF-6X2 Digital EMS Instruction Manual Drive DeVilbiss Healthcare 99 Seaview Boulevard Port Washington, NY 11050 Tel: 877- 224-0946 www.drivemedical.com REV 1.03.29.17...
  • Page 2: Table Of Contents

    INDEX Chapter Contents Page Introduction ............2 Cautions ..............3 Warnings ............... 4 Contraindications ..........4 Adverse Reactions ..........4 General Description ..........5 Construction............6 Technical Specifications ........8 Replacement Parts ..........10 10. Accessories ............10 11. Graphic Symbols ..........11 12.
  • Page 3: Introduction

    John Faraday in 1831. Through the square wave pattern it is 2. Safety of powered muscle stimulators for use during pregnancy able to work directly on muscle motor neurons. The AGF-6X2 Digital has not been established. EMS has low frequency and this in conjunction with the square 3.
  • Page 4: Warnings

    Chapter 3 : WARNINGS Chapter 6: GENERAL DESCRIPTION 1. The long-term effects of chronic electrical stimulation are AGF-6X2 Digital EMS is a battery operated pulse generator unknown. that sends electrical impulses through electrodes to the body and 2. Stimulation should not be applied over the carotid sinus nerves, reaches the underlying nerves or muscle group.
  • Page 5: Construction

    Chapter 7 : CONSTRUCTION (1 ) MODE (2 ) TIMER (3 ) PULSE W IDTH / RATE (4 ) RAMP / ON / OFF TIMER (5 ) OUTPUT INDICATOR FRONT (1) LEAD CONNECTOR (2) INTENSITY CONTROL ( ON/OFF SWITCH) (3) LIQUID CRYSTAL DISPLAY (4) MODE CONTROL (5) SET CONTROL (6) INCREMENT CONTROL...
  • Page 6: Technical Specifications

    The stimulation of the CH2 will occur after the 1st contraction of CH1 is completed. In this mode, the setting of ON Time should The technical specification details of AGF-6X2 Digital EMS are as follows: be no less than two times of the “Ramp” MECHANISM TECHNICAL DESCRIPTION time.
  • Page 7: I. Access Ories

    Chapter 9 : REPLACABLE PARTS Chapter 11 : GRAPHIC SYMBOLS The replaceable parts and accessories of AGF-6X2 Digital Note Operating Instructions devices are as given below –Except leads, electrodes, battery and battery case cover, please do not try to replace the other parts of Degree of Electrical Protection BF a device.
  • Page 8: Operating Instructions

    After connecting the wires to the stimulator, attach each wire to Chapter 12: OPERATING INSTRUCTIONS an electrode. Use care when you plug and unplug the wires. Jerking the wire instead of holding the insulated connector body 1) Insert the 9V battery into the device’s battery compartment. may cause wire breakage.
  • Page 9: Tips For Skin Care

    the initial results are not positive, speak to your physician about Chapter 18: APPLICATION OF RE-USABLE SELF alternative stimulation settings and/or electrode placements. Once ADHESIVEELECTRODES an acceptable placement has been ac hieved, mark down the electrodes sites and the settings, so the patient can easily continue treatment at home.
  • Page 10: Adjusting The Controls

    To reduce the current strength or switch the device off, turn the Important control counter clockwise to the required setting or off-position, 1. Do not apply to broken skin. respectively. 2. The electrodes should be discarded and re-ordered from your The controls are protected by a cap to avoid unintentional change physician when they are no longer adhering.
  • Page 11 5. Set Control 9. Steps to Set a New Program By pressing the “Set” control, you may enter the setting you The settings can be adjusted according to the following steps. intend to make adjustment. You may start to set the value by a.Turn on the Intensity pressing the “Increment”...
  • Page 12 menu. By pressing the increment and decrement controls, the In Alternate mode, the OFF Time should be equal or more than the ON Time. (OFF TIME ≥ ON TIME) number of current impulses per second (Hz) for both channels can be continually adjusted. The pulse rate is adjustable from 2 Hz to 150 Hz.
  • Page 13: Battery Information

    10.Check/Replace the Battery: BATTERY CHARGING Over time, in order to ensure the functional safety of TENS, changing the battery is necessary. (1) Plug the charger into any working 110 or 220/240v mains 1. Make sure that both intensity controls electrical outlet. The use of any attachment not supplied with are switched to off position.
  • Page 14: Maintenance, Transportation, And Storage Of Tens Device

    Chapter 23 : MALFUNCTIONS 1. Non-flammable cleaning solution is suitable for cleaning the device. Should any malfunctions occur while using the AGF-6X2 Digital Note: Do not smoke or work with open lights (for example, EMS, check candles,etc.) whether the parameters are set to the appropriate form of when working with flammable liquids.
  • Page 15: Warranty

    Chapter 25: WARRANTY (Appendix I) Test Environment AGF-6X2 Digital EMS models carry a warranty of three SCOPEPROBE(GND) years f rom the date of delivery. The warranty applies to the stimulator only and covers both parts and labor relating thereto. SCOPEPROBE...
  • Page 16: Appendix

    2. Synchronous Mode (Appendix II) Waveform of AGF-6X2 Digital EMS Load: 500 ohm 1. Constant Mode Pulse Rate: 150Hz Load: 500 ohm Pulse Width: 300µs Pulse Rate: 150Hz Contraction Time:12 Sec Pulse Width: 300µs Relation Time:12 Sec Ramp Time:6 Sec Scope A : VERT:10.0V/DIV...
  • Page 17 3. Alternate Mode Load:500ohm Pulse Rate:150Hz Pulse W idth:300µs Contraction Time:12 Sec Relation Time:12 Sec Ramp Time:6 Sec...

Table of Contents