Using Your Unit - Poulan Pro 530086848 Instruction Manual

Rib
Groove
Insert the elbow tube into the blower outlet.
D
Make sure elbow tube rib is aligned with the
blower outlet groove.
Turn clamp knob clockwise to tighten.
D
VACUUM TUBE ASSEMBLY
WARNING:
Stop engine and be sure
the impeller blades have stopped turning be-
fore opening the vacuum inlet door or at-
tempting to insert or remove the vacuum or
blower tubes. The rotating blades can cause
serious injury.
Align the lower vacuum tube as shown.
D
Push lower vacuum tube into upper vacu-
um tube.
Upper Vacuum
Tube
Lower Vacuum Tube
Insert a screwdriver into the latch area on
D
the vacuum inlet cover.
Blower
Latch
Outlet
Area
Gently tilt the handle of the screwdriver to-
D
ward the back of the unit while pulling up on
the vacuum inlet cover with your other
hand.
Hold the vacuum inlet cover open until up-
D
per vacuum tube is installed.
Vacuum Inlet
Retaining Post
Vacuum
Inlet
Cover
Place the hooks on the vacuum tube on the
D
retaining posts; pivot tube into position. Se-
cure vacuum tube by turning the knob
clockwise until tight.
When converting back to the blower fea-
D
ture, make sure latch on the vacuum inlet
cover is securely fastened.
SHOULDER STRAP ADJUSTMENT
Hold the unit as shown.
D
Pass the shoulder strap over your head and
D
onto your right shoulder.
Extend your left arm toward the rear of the
D
vacuum bag.
Adjust shoulder strap until the vacuum bag/
D
shoulder strap seam lies between your
thumb and index finger.
Make sure air flows freely from the elbow
D
tube into bag. If bag is kinked, the unit will
not operate properly.

USING YOUR UNIT

Latch Area
Vacuum
Inlet Cover
WARNING:
the tubes are secure before using the unit.
OPERATING POSITION
Eye
Protection
Blower
OPERATING TIPS
S While vacuuming or blowing debris, hold
the unit with the muffler side facing away
from your body and clothes (see illustration
above).
-- 4 --
Knob
Hooks
You MUST make sure
Vacuum