Rear Panel - Onkyo TX-RZ3100 Basic Manual

> Before start > Hookup

Rear Panel

1
14
13 15
1. COMPONENT VIDEO IN/OUT jacks: Transfer the video
signals of an AV component with a component video cable.
2. ZONE 2/ZONE 3 PRE/LINE OUT jacks: Output audio
signals with an analog audio cable to a pre-main
amplifier or a power amplifier in a separate room (ZONE
2/ZONE 3). ( P18, 19)
3. HDMI IN jacks: Transmit video signals and audio signals
with a HDMI cable connected to an AV component.
4. VIDEO IN jacks: Input the video signals from AV
components with an analog video cable.
5. AUDIO IN jacks: Input TV or AV component audio
signals with an analog audio cable.
6. GND terminal: The ground wire of the turntable is connected.
7. HDMI OUT jacks: Transmit video signals and audio
signals with a HDMI cable connected to a monitor such
> Setup
2 3 4 5 6
17
16
as a TV or projector.
8. ETHERNET port: Connect to the network with an
Ethernet cable.
9. USB port: A USB storage device is connected so that music
files stored in it can be played. You can also supply power
(maximum 5V/1A) to USB devices with a USB cable.
10.DIGITAL IN OPTICAL/COAXIAL jacks: Input the digital
audio signals from TV or AV components with a digital
optical cable or digital coaxial cable.
11. Wireless antenna: Used upright for Wi-Fi connection or
when using a BLUETOOTH enabled device. The
diagram shows the movable range for the wireless
antenna. Do not try to force it beyond this range
otherwise you may break it.
12.AC INLET: The supplied power cord is connected.
> Playback > Part Names
7 8 9
18
19
10 11 12
13. RS232 port: For connection to the home control system.
14. 12V TRIGGER OUT jacks: Allows you to connect a
device with 12V trigger input jack to enable link operation
between the device and the unit.
15. IR IN port: Allows you to connect a multiroom remote
control kit.
16. TUNER AM/FM 75Ω terminal: The supplied antennas
are connected.
17. SPEAKERS terminals: Connect speakers with speaker cables.
(North American models are compatible with banana plugs.)
18. SUBWOOFER PRE OUT jacks: Connect a powered
subwoofer with a subwoofer cable. Up to two powered
subwoofers can be connected. You can set the volume
levels of the 2 powered subwoofers to different levels.
19. PRE OUT jacks: Connect a power amplifier.
11
31