MX Group Inspiration QI Installation Instructions Manual

MX Group Inspiration QI Installation Instructions Manual

Instantaneous electric shower

Advertisement

Inspiration
QI
Instantaneous Electric Shower
Installation Instructions
IMPORTANT!
This Step-by-Step guide should be given to the customer
after installation and demonstration.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Inspiration QI and is the answer not in the manual?

Questions and answers

Summary of Contents for MX Group Inspiration QI

  • Page 1 Inspiration Instantaneous Electric Shower Installation Instructions IMPORTANT! This Step-by-Step guide should be given to the customer after installation and demonstration.
  • Page 2: Contents & Features

    CONTENTS & FEATURES 1. PLEASE READ THIS IMPORTANT SAFETY INFORMATION Products manufactured by the MX Group are safe • 4. Riser Rail Bracket and without risk provided they are installed, used and QUICK INSTALLATION maintained in good working order in accordance with our a guide for installers •...
  • Page 3 1. PLEASE READ THIS IMPORTANT SAFETY INFORMATION (CONT.) IMPORTANT: Turn the Temperature control knob anticlockwise until the valve is fully open before switching on the unit. This will ensure a fast fill up of the unit IMPORTANT: This appliance is not intended for use by persons (Including children) when the shower is first switched on.
  • Page 4 NOT be connected to any form of tap or fitting not supply with a minimum running pressure of 100kPa 8. Fitting the cover ......................recommended by the MX Group. (15 lb/sq in) - (1 Bar) at a minimum flow rate of 8 litres per minute. The maximum static pressure 9.
  • Page 5: Installation

    4. GENERAL LAYOUT OF A SHOWER INSTALLATION 5. INSTALLATION A TYPICAL INSTANTANEOUS ELECTRIC SHOWER Avoid connecting the shower unit, if possible, Position your shower unit on the wall away from the Place the shower unit on the wall and mark the INSTALLATION were it will be affected by water drawn off by other direct spray of the shower and at about the same...
  • Page 6: Plumbing Connections

    6. PLUMBING CONNECTIONS PLUMBING CONNECTIONS Water inlet direction option Turn off the water supply at the isolating stop tap. Having determined the direction of the inlet water NOTE! The shower unit is supplied for right hand installation. The 8 arrows depict water Location holes for supply: Top (falling), Bottom (rising), or Back inlets.
  • Page 7 7. ELECTRICAL CONNECTIONS ELECTRICAL SPECIFICATIONS The diagram below shows the route of the cable into The diagram right shows a schematic wiring the shower unit for connection to the terminal blocks, diagram. Nominal Power rating at 240V Nominal Power rating at 230V connect as follows: 7.5kW - (32A MCB rating) 6.9kW - (32A MCB rating)
  • Page 8: Riser Rail Fitting Instructions

    9. RISER RAIL FITTING INSTRUCTIONS 10. COMMISSIONING THE SHOWER 1. Establish holes to be used. 1. Make sure that the electrical supply has been 7. Turn the bottom temperature control knob isolated at the double pole isolating switch. clockwise for hotter water and anti-clockwise 2.
  • Page 9: Operating The Shower

    11. OPERATING THE SHOWER 12. SHOWERHEAD CLEANING INSTRUCTIONS 1. Switch on pull-cord or wall mounted switch. To increase the shower temperature. The showerhead should be cleaned periodically to remove limescale or debris which will The ‘Power’ neon will illuminate indicating Turn the temperature control knob clockwise, reduce the performance of the shower.
  • Page 10: Faq's - Frequently Asked Questions

    13. FAQ’S - FREQUENTLY ASKED QUESTIONS Q. Water does not flow when turned on. Q. Water too cool or cold. Q. The shower hose or showerhead is damaged, Q. Power setting will not remain on the setting I have leaking or otherwise unsatisfactory. selected.
  • Page 11: Service Policy

    MX Group is limited to the cost of the component. Customer Care Department 8. If a product is deemed to be of faulty manufacture MX Group will at Exclusions: their discretion replace the component. Any related consequential Telephone: 0845 505 2211 Fax: 0845 850 0757 1.
  • Page 12 NOTES NOTES...
  • Page 13 Marleton Cross Limited Trading as The MX Group Alpha Close, Delta Drive, Tewkesbury Industrial Estate, Tewkesbury, Gloucestershire GL20 8JF Tel: 01684 293311 Fax: 01684 293900 Email: sales @ mx-group.com www.mx-group.com CUSTOMER CARE: 0845 5052211 TRADE DESCRIPTIONS ACT Variations in terms of colour finish, materials and all other aspects of appearance may occur on occasions, either through non-availability of materials or due to our policy of continuing technical improvement.

Table of Contents

Save PDF