MIG-29 Park Jet INSTRUCTION MANUAL Warranty The contents of this kit are guaranteed to be free of defects at time and date of purchase. The warranty doesn’t cover modifications to kit, or damage to Components used in combination with this product. Yardbird RC will only cover the replacement of this kit for defects at time of purchase.
Thank You Thank you for your purchase of the Yardbird RC Mig-29 Park Jet. It is our sincere hope that this product Test Fit: Means to assemble the pieces without will bring you many hours of fun and safe enjoyment.
Kit Contents Part Name Part # Canopy 0129 Upper Fuselage 0229 Upper Fuselage 0229 Lower Fuselage 0329 Lower Fuselage 0329 Left Wing Deck 04L29 Right Wing Deck 05R29 Aft Wing Deck 06L29 L Vertical Stabilizer 06R29 R Vertical Stabilizer 07L29 Left Elevon 08R29 Right Elevon...
Kit Construction Step 1. Step 4.1 Use care with the X-ACTO knife! Test fit and glue the 6 inch pieces of carbon fiber into the 6 inch channels in the elevons. Use the X-ACTO knife to remove the milling tabs on all Step 4.2 the foam parts.
Page 5
Step 6 .1 Step 9. Glue the aft fuselage pieces flush with the edge as shown Cut the two separate ½ slots for the opposite end of the fiber hinges. above. Don’t apply glue to the 1 inch by ½ inch servo Now slip the fiber hinges into the belly plate slots to complete the step.
Step 12. Step 16. Cut a 1/2 inch section from the Velcro strip. Attach it to the inside of the access door aft of the round hole. Test fit and glue the brace assembly into the fuselage as pictured above. Take care to glue the brace on top of and Step 17.
Paint and Decal Installation Step 19. Paint Paint is optional. Paint adds weight and painting the entire model is not recommended. Always use foam safe paint. Test all paints on the test piece before applying to the model. Always paint in a well ventilated area and follow the directions for the paint chosen.
Servo and Push Rod Installation Step 21. Step 25. Test fit and glue the cockpit in place as shown in the above picture. If you plan to paint the kit you may wish to glue the cockpit on after painting. Attach the motor to the engine mount using the motor mount screws.
Setup Step 28. Step 30. Setting Control Direction Take care around the prop. You may wish to remove or wait to install the prop until after the control direction setup. Power Up the transmitter and receiver. Center all the trim levers. With the trim levers centered check the two elevons.
Once you have got the aircraft trimmed out and a familiar and comfortable with the launch and climb out. The alternate launch method MIG-29 Park Jet is to lightly grasp the model with you right hand. Your thumb in the gap between the two elevons and your fingers spread under the aft wing deck.