Installation; Connecting To The Mains - AEG Micromat 201 User Manual

MC201

Installation

1. Remove any promotion label from the door.
2. The oven should be installed on a flat, level surface. The surface must be strong enough to
safely bear the weight (13.5 kg) of the oven, and the contents. To avoid the possibility of
causing vibration or noise the oven must be in a stable position.
3. Keep the oven away from heat and water. Exposure to heat and water can lower oven
efficiency and lead to malfunctioning, so be sure to install the oven away from heat and
water sources.
4. Do not block air vents on the top and the sides of the cabinet and also do not place any
articles on the top of the oven. If air vents are blocked during operation, the oven may
overheat, and this may lead to malfunctioning. Hot air escapes from the vents, so be sure
not to obstruct it or let curtains come between the oven and the rear wall.
5. Place the oven as far away from radios and TV's as possible. This oven does conform to EEC
requirements of radio interference suppression, but some interference may occur if it is
placed too close to a radio or TV, so keep them as far apart as possible.
6. If positioned in a corner, leave a gap of at least 15 cm from the walls and 15 cm above the
microwave.

Connecting to the mains

The oven is delivered with the power cord and a plug for 240V, 50Hz, earthed socket outlet. Earth
protection minimises the risks should a short circuit occur. Check to ensure the voltage of the
oven matches the supply.
N.B. If the oven is connected to the socket via an extension cord, make sure the cord is earthed.
MPORTANT! The oven can be placed almost anywhere in the kitchen. Make sure
the oven is placed on a flat, level surface and that vents as well as the surface
underneath the oven are not blocked (for sufficient ventilation).
This appliance must not be used on a non-earth protected power supply.
Contact an electrician if you are uncertain regarding electrical connection of
the oven or provision of earth protection of the supply.
This appliance must be earthed. If this appliance is fitted with a non-
rewireable plug for which your socket is unsuitable, the plug should be cut off
and the appropriate plug fitted. If it is necessary to change the fuse in a non-
rewireable plug, the fuse cover must be refitted. If the fuse cover is lost or
damaged, the plug must not be used until a replacement is obtained.
English
9