Subscribe to Our Youtube Channel
Related Manuals for Artos Denby M06860W
Summary of Contents for Artos Denby M06860W
-
Page 1: Installation Guide
Installation Guide Denby Towel Warmer M06860W ( hardwired version ) - Page 2 The Denby Towel Rack is intended for towel warming/drying, auxiliary heating or as a decorative product. The average heat up time is about thirty minutes, but would depend on a ) the size of the unit and b ) the initial temperature of the unit. Typically the unit is programmed to be on an hour before expected use and remain on for an hour afterwards.
-
Page 3: Technical Specifications
TECHNICAL SPECIFCATIONS TECHNICAL SPECIFICATIONS Rev 01/08 MODEL# M06860 ELECTRIC VERSION Element specifications 300W, 110V, 48” cord, UL approved. Hardwire Kit CSA-US approved. File ref: 229718 HYDRONIC VERSION Heat ouput 1845 BTU. ½” BSPT tappings. Steel towel warmers should only be used in a closed water system, incorporating a rust inhibitor. -
Page 4: Installation Steps
INSTALLATION STEPS 1. Check that all the installation pack contents have been received. There should be 3 items as shown below: Timer Brackets Hardwire Kit 2. DISCONNECT POWER SUPPLY. Connect timer to power supply. The timer can be placed anywhere in the room ( recommended beside the light switches ) . Refer to in- structions provided with timer for wiring details. - Page 5 INSTALLATION STEPS 5. Determine location of #6 outer rear cylinder by measuring the brackets attached to towel warmer. Attach #6 cylinder to wall with hole for #7 locking screw facing down on the bot- tom brackets and facing up on the top brackets. 6.
- Page 6 Under the warranty we will provide replacement components or product at our discretion. Westover, Inc is not responsible for labor charges connected with removal or installation. PLEASE REGISTER THIS PRODUCT ONLINE AT WWW.ARTOS-WESTOVER.COM...
Need help?
Do you have a question about the Denby M06860W and is the answer not in the manual?
Questions and answers