Summary of Contents for Forever Tan Ergoline Open Sun 1050
- Page 1 Ergoline Open Sun 1050 Forever Tan 113 Freeland Lane Charlotte, NC 28217 1-800-447-0040 For questions concerning this guide please contact Jeremy Welch: jeremyw@forevertan.net (704)971-4744...
- Page 2 1-inch liquid-tight flex connector. It will then require a 230- volt, 130 amp, (3 wire) circuit – actual amp draw of 98 amps. If you require a unit to be single phase you must contact the Forever Tan Delivery Department before delivery at 1-800-447-0040.
- Page 3 Forever Tan will take no responsibility for any miscalculations or any misprints. *** Forever Tan will allow all beds to be cord and plug connected. Forever Tan requires that the conversion from hard-wire to cord and plug be made externally.
- Page 4 80 amp rated - Jefferson 415-0001-043 (3 Phase 208Y to 235Y volts) Call Forever Tan Parts Department for Pricing – 1-800-447-0040...
- Page 5 IMPORTANT Forever Tan does not do any pre-wiring or installing of timer wires. We recommend having an electrician do this for you. The wire is available from the Forever Tan Parts Department. No employee of Forever Tan is allowed (either written or verbally) to include any timer wiring with any purchase of tanning equipment from Forever Tan.
- Page 6 SINGLE GANG OUTLET BOX - THIS IS WHERE THE 24 GAUGE 4 CONDUCTOR SHIELDED CABLE MUST START FROM. 120 VOLT OUTLET WITHIN 4 FEET OF WHERE THE TIMER WILL BE PLACED. E600 Forever Tan does not mount timers on the walls.
- Page 7 Placement of single gang box Advantage, Excellence,A containing network wire for the dvantage and following equipment models: all Soltron Front of bed units All Sundash , Ergoline All Sundash, Ergoline and and Soltron units. Soltron units. This placement is approximately 12 inches off side wall and 24 inches from the floor Side wall...
-
Page 8: Speaker Placement
If a music source is to be used the audio installer must have the wiring in place before delivery and must be present when the equipment is installed. Forever Tan has to turn on this feature and adjust the input volume so that it will conform to the volume of the source. - Page 9 Open Ceiling vs. Dropped Ceiling Forever Tan has found that (if feasible) it is best to leave the ceiling open. If the ceiling is open and the A/C is piped down it allows the heat to rise past cool air. This makes it easier for the cool air to reach the floor.
Need help?
Do you have a question about the Ergoline Open Sun 1050 and is the answer not in the manual?
Questions and answers