Table of Contents
Advertisement
Operating Instructions for MSE Three-Way Recovery Winch
Personal Fall Arrest Device, Self Retracting Lifeline with retrieval winch.
This
instruction
manual
installation,
operation,
maintenance procedures for the product
listed above.
WARNING! You must read and fully understand all
instructions, or have all instructions explained to you,
before attempting to use this device. Equipment must
not be installed, operated or inspected by anyone who
does not understand this Owner's Manual. Failure to
observe these instructions could result in serious
injury or death. Careless or improper use of this
equipment can result in serious injury or death.
Training and instructions review should be repeated
at regular intervals. If you have any questions
regarding these instructions or need additional copies,
please call Mechanical Safety Equipment Corp. at
215-676-7828
General
THREE-WAY RECOVERY WINCH is designed for use in confined spaces such as manholes, tanks, and other confined areas, where fall-
arrest and retrieval rescue are important. The winch operates as a retractable as well, to raise and lower a worker.
In the situation where a ladder or other means of descent and ascent is in place, a worker should be attached to a Three-Way Recovery
Winch.
Functions:
•
Fall Arrest – a braking action if a worker falls
•
Retrieval – a means for a topside worker to raise another worker
•
Reverse direction - a means for the topside worker to reverse directions, if for any reason the worker becomes wedged while
retrieval is in progress
Note: A Three-Way Recovery Winch, when used in conjunction with anchors such as (Tripod, Quadpod, Monopod or Davit) with optional
Personnel or Work Winch is called a Three-Way Recovery System.
WARNING: This unit is NOT meant to hold or
suspend a worker.
The capability to raise a
worker (retrieval) should only be used for rescue
operations; NOT for routine lifting. If suspension
or non-rescue retrieval capabilities are required,
use the Personnel Winch Model no. 142.
material will be lowered and raised with a
material handling winch Model no.140
Mechanical Safety Equipment Corp.
Model 2005
covers
the
inspection
and
All
Suspension
Retrieval
Advertisement
Table of Contents
Summary of Contents for Mechanical Safety Equipment 2005
- Page 1 Training and instructions review should be repeated at regular intervals. If you have any questions regarding these instructions or need additional copies, please call Mechanical Safety Equipment Corp. at 215-676-7828 General THREE-WAY RECOVERY WINCH is designed for use in confined spaces such as manholes, tanks, and other confined areas, where fall- arrest and retrieval rescue are important.
-
Page 2: Installation Procedures
Three-Way Recovery Winch Installed on Tripod Personnel Winch Model 142 Three-Way Recovery Winch Model 2005 Label For Three-Way Recovery Winch attachment For 3 WAY Unit Model 2005 INSTALLATION PROCEDURES Attach the Three-Way Recovery Winch to inside of one Tripod leg making sure the unit’s bracket is aligned so that both locking pins can be fully pushed-... - Page 3 Quadpod System Boom Label For Three-Way Recovery Winch attachment Three-Way For 3 WAY Unit Recovery Winch Model 2005 Model 2005 Personnel Winch Model 142 INSTALLATION PROCEDURES Davit System Three-Way Recovery Winch attaches to a boom with two locking pins (see picture above). Attach the Three-Way Recovery Winch to the boom (the attachment point is marked with a label).
- Page 4 Three-Way Recovery Unit Installed on Monopod Personnel Winch Model 142 Rescue and Recovery Winch Model 2005 Monopod System Label For Three-Way INSTALLATION PROCEDURES Three-Way Recovery Winch attaches to a monopod with two locking pins (see Recovery Winch attachment picture above). Attach the Three-Way Recovery Winch to the monopod (the attachment point is marked with a label).
-
Page 5: Inspection Procedures
INSPECTION PROCEDURES WARNING Never use the winch without thorough inspection before each use Inspect the work area for debris and other material that could cause injury or interfere with the operation of the unit. Be sure that the Tripod, Quadpod, Davit and Monopod are positioned on a stable, hard ground before setting it up. The leg chains (for Tripod) and all locking pins should be checked to assure correct securing of the equipment. -
Page 6: Operation Procedures
Operation Procedures Read and complete all instructions listed in the “Inspection Procedures” section. Unscrew the handle from the mounting bracket and slide it outward. After successful testing, a worker can now be attached to the winch via attaching the swivel snap hook at the end of the cable to the back center “D”... - Page 7 Never attempt to lubricate, adjust, repair or modify any part of the winch. Repair and recertification MUST BE performed by Mechanical Safety Equipment Corp. annually, or more frequently, depending of the use and operating conditions, or whenever subjected to a severe free fall.
-
Page 8: Technical Information
Technical Information Principles of Design Combination of Fall Arrest/Retrieval Device and Self Retracting Lifeline. Body Construction Casted Aluminum Cable Length 50 – 100 ft. Cable Material Galvanized Steel, Stainless Steel, Synthetic Rope Cable Diameter 3/16” (4.8 mm) Cable Breaking Strength 4,200 lbs. - Page 9 WARNINGS Read, understand and follow all instructions and warnings, attached to and/or packed with this unit before each use. Do NOT use winch if any instruction or warning is not fully understood. Telephone MSE Corp. at 215-676-7828 for clarification. For use by properly trained personnel only. Inspect Before Each Use.
- Page 10 Inspection and Maintenance Log SERIAL NO. MODEL NO. DATE PURCHASED: Inspection Inspection Items Noted Corrective Action Taken Maintenance Performed Date Approved by: Approved by: Approved by: Approved by: Approved by: Approved by: Approved by: Approved by: Approved by:...
- Page 12 Mechanical Safety Equipment Corp. 2070 Bennett Rd Philadelphia PA, 19116 Phone: 215-676-7828 Fax: 215-676-5199 www.msecorporation.com...
Need help?
Do you have a question about the 2005 and is the answer not in the manual?
Questions and answers