General Installation; Leveling Information; Installation Tip - U-Line 1224RF User Manual & Service Manual

USER GUIDE
SAFETY • INSTALLATION & INTEGRATION • OPERATING INSTRUCTIONS • MAINTENANCE • SERVICE

General Installation

LEVELING INFORMATION

1. Use a level to
confirm the unit is
level. Level should
be placed along top
edge and side edge
as shown.
1
2. If the unit is not level, adjust the legs on the
corners of the unit as necessary.
3. Confirm the unit is level after each adjustment and
repeat the previous steps until the unit is level.

INSTALLATION TIP

If the room floor is higher than the floor in the cutout
opening, adjust the rear legs to achieve a total unit
rear height of 1/8" (3 mm) less than the opening's
rear height. Shorten the unit height in the front by
adjusting the front legs. This allows the unit to be
gently tipped into the opening. Readjust the front legs
to level the unit after it is correctly positioned in the
opening.
INSTALLATION
1. Plug in the power/electrical cord.
Turn to Adjust
2. Gently push the unit into position. Be careful not to
entangle the cord.
3. Re-check the leveling, from front to back and side
to side. Make any necessary adjustments. The
unit's top surface should be approximately 1/8" (3
mm) below the countertop.
4. Remove the interior packing material and wipe out
the inside of the unit with a clean, water-
dampened cloth.
u-line.com
Anti-Tip Bracket 1