Microsport OWUACAMP915 User Manual

Jogging/Walking Speedometer
User Manual

1. Quick Start Guide

READ THIS FIRST
If at any point in these instructions you
have questions, please call +49 (0)89
30725599 or write an e-mail to
service@microsport.de.
Display:
a. To begin, reset your receiver/watch
by pressing all four outer buttons un-
til the screen goes blank.
b. In Time Mode T, press SET button -
upper left.
c. To change a value, press + button
(upper left) and - button (lower right).
d. Press START/STOP button (upper
right) to save the changes and con-
tinue to the next option- 12/24hr
time, time, date, etc.
e. You can always exit the Setup by
pressing MODE
Speed and Distance:
Jogging/Walking Speedometer
Table of Contents:
1. Quick Start Guide
2. Wrist Strap Installation/Removal
3. Setting the Time
4. Time Mode T
5. Speed Mode S
6. Distance Mode D
7. Heart Rate Mode ♥
8. Memory Mode M
9. Calibration Methods
10. Changing the Batteries
11. Additional Information
12. Trouble Shooting
13. Remarks
a. The accelerometer module can be
worn either as a stand alone unit or
as part of a heart rate chest strap.
ATTENTION: The Heart Rate can
only be detected when used with the
chest strap.
b. The Speed Module is activated when
inserted into the chest strap or the
belt clip. ATTENTION: Don't forget
to remove the Speed Module after
usage in order not to drain the bat-
tery.
c. Press MODE (lower left on the
watch) and scroll to the S Speed or
D Distance setting.
d. Press START/STOP (upper right) to
begin data collection- as indicated by
the Symbol below the status bar.
e. If the speed module could connet to
the display all data and functions are
displayed.
nCon:
Jogging/Walking Speedometer
This means the receiver is not able to
establish a wireless connection with the
accelerometer module. To correct this:
a. Remove the accelerometer from
both sides of the belt clip or chest
strap and reconnect.
b. Press all four buttons until the screen
goes black and an r appears fol-
lowed by a number. Press
START/STOP; this clears all mem-
ory and time.
c. Change the battery in the acceler-
ometer module and the display. See
section 11.
Getting Started:
Your receiver/watch has a user friendly
menu system. The lower left button
toggles through the MODES, and the
lower right button toggles through the
OPTIONS within each MODE. The dif-
ferent Modes are:
T TIME
S SPEED
D DISTANCE
♥ HEART RATE
M MEMORY
Locate the lower left button and toggle
through the five modes. The OPTIONS
within each MODE are listed below.
When in a particular mode, press the
OPTION/- button to view the various
options. Press MODE to return to the
main view at any time. The functions are
divided into the different main modes as
follows:
T: Time/date, Alarm 1, Alarm 2, Count-
down Timer, Stopwatch, Stopwatch
nd
History, 2 Time Zone
S: Actual-, Average-, Maximum Speed,
Actual-, Average Pace
D: Trip Distance, Trip Time, Totsl Dis-
tance, Trip Calories, Total Calories,
Lap Counter