Vertu V collection Manual page 13

headset.book Page 13 Thursday, May 28, 2009 12:39 PM
To reject a call, press the multifunction key twice, or use the keys of the
phone.
To end a call, press the multifunction key once, or use the keys of the
phone.
Press the left volume key to increase the volume or the right volume key
to decrease the volume or use the keys of the phone.
To switch a call from the headset to a connected phone, push the
earpiece into the upright OFF position, or use the keys of your phone.
To switch a call to the headset, push the earpiece into the horizontal ON
position and connect it to the paired phone. Or press and hold the
multifunction key for about 2 seconds when the headset is on, depending
on your phone model.
To clear all the pairing settings from the headset, push the earpiece into
the horizontal ON position and then press the multifunction key for at
least 8 seconds until the red and green indicator lights start to alternate.
After the settings are cleared, the headset enters the pairing mode.
To reset the headset if it stops functioning (even though it is charged)
push the earpiece into the upright OFF position, connect the charging
adaptor to an electrical source using a charging cable and place the
headset in the charging adaptor. This does not clear the pairing settings.
English 13