Rheem IQ Owner's Manual page 20

ADVANCED SETUP & ADVANCED FUNCTIONS
3. Press and release
move to the next digit etc). When the last digit has been set press and release
4. Press and release
5. Press and release
6. Press and release
Model
A2WHH
A2WHR
A2WHC
A2WC
REMOTE
W2WH
W2WHC
W2WC
7. Press and release
of compressors.
8. Press and release
9. Press and release
10. Press and release
11. Press and release
the home screen and step 2 settings will be saved.
Step 3 – Setting Configuration 03 ~ 06 Screen Parameter Settings
Refer to the relevant 'Manufacturer Screen Parameter Settings' table for appropriate parameter
values according to the model Heat Pump installed. Tables start on page 26.
1. Whilst in the home screen, press and release
screen.
2. Press and release
3. Press and release
move to the next digit etc). When the last digit has been set press and release
step will not occur if the password has been previously entered within 10 minutes.
4. Press and release
5. Press and release
6. Press and release
7. Use to move curser and use
parameter settings.
8. Press and release
9. Press and release
10. Repeat steps 7 ~ 9 to set parameter values for all remaining configuration screens. When all
configuration screen parameter values have been set, proceed to step 11. Note: When
setting 'Configuration 05' and 'Configuration 06' parameter settings using a pressure
transducer, refer to 'LP & HP Pressure Sensor Parameter Settings Tables' on page 21 for
indicative pressure settings (pressure settings are not required if using a pressure switch).
11. Press and release
the home screen and step 3 settings will be saved.
and enter the four digit password '2170' (Set first digit then press
or until 'a. Configuration'
to navigate to 'Configuration 01' screen.
to move curser to 'Model' and set to appropriate model as follows:
Air to Water Heat Pump with Hot Gas De-Ice
Air to Water Heat Pump with Reverse Cycle De-Ice
Air to Water Heat and Cool
Air to Water Chiller
Other controls such as AC1 or Saginomiya De-Ice will control unit main functions
Water to Water Heat Pump
Water to Water Heat and Cool
Water to Water Chiller
to move curser to 'No.Compressors' and set to the appropriate number
to move curser to 'Reverse cycle' and set to the appropriate value.
to move curser to 'Defrost type' and set to the appropriate value.
. The curser will disappear.
three times to go back to the home menu. The screen will change to
or until 'H. Manufacturer'
and enter the four digit password '2170' (Set first digit then press
or to until 'a. Configuration'
to navigate to navigate to 'Configuration 01' screen.
to navigate to 'Configuration 03' screen.
or
until the curser disappears.
to navigate to the next configuration screen.
three times to go back to the home menu. The screen will change to
is selected.
Description
. The screen will change to the 'Main menu'
is selected.
is selected.
to set values for all 'Configuration 03' screen
20
to
.
to
. Note: This