Advertisement
Quick Links
GAVI FOLDING WORKBENCH INSTALLATION INSTRUCTIONS
The GAVI Folding Workbench is shipped in 2 BOXES (1 box containing the tabletop
and 1 box containing the metal parts). Note that the metal brackets are preassembled
in the middle table height position (approximate 36" table height). The table height can
be adjusted after installation. Table height adjustment instructions are on page 3.
Tools required for installation: #2 Square Drive Bit (included),
5/32" Allen Wrench (included), Phillips Head Screwdriver.
Before you begin, decide where you are going to install the tabletop, making
sure you have at least a minimum of 52" of unobstructed wall space.
Disclaimer: The screws provided with the GAVI Folding Workbench are for wood stud installations only. Other applications
may require different screws for proper and safe use. It is the buyer's responsibility to research, secure and use the right
screws for applications other than wood studs.
Step 1: On the wall where the workbench will be mounted, using a stud finder, find the center of the stud for mounting
the left bracket. Place a reference mark at the center of the stud 68" from the floor. (See fig. A)
Center of Stud
Floor
Step 2: Attach the left bracket through the 1st hole at the top, using the supplied
screw. (Black #8 x 2" long - Part# 21347-19) Do not tighten the screw all of the
way at this time. (See fig. B)
Step 3: Use a level so the bracket is vertically straight. Make sure to place the
level against the flat part of the bracket and not against any screw heads along
the side.
Step 4: Without moving the level, mark the center of the last hole at the bottom of
the bracket. Attach with a screw and tighten all of the way. Then, go back to the
top screw and finish tightening it all of the way.
6 8 "
For questions, contact Sue at (847) 387-6704 or suzanne@gavipop.com.
Visit gavipop.com/foldingworkbench for installation videos and additional information.
Wall
Wood Stud
A
LEFT BRACKET INSTALLATION
Install first
screw in first
hole
Bracket Leg
Install second
screw in
bottom hole
B
Revised 3/22/16
Advertisement
Subscribe to Our Youtube Channel
Summary of Contents for GAVI Folding Workbench
- Page 1 52” of unobstructed wall space. Disclaimer: The screws provided with the GAVI Folding Workbench are for wood stud installations only. Other applications may require different screws for proper and safe use. It is the buyer’s responsibility to research, secure and use the right screws for applications other than wood studs.
- Page 2 (Silver #10 x 3/4” long Part# 21347-5) 6 screws total - (See fig. E) With the butcherblock tabletop, it’s recommended to pre-drill 1/8” holes ¾” deep. Left Bracket The GAVI Folding Workbench is now ready to be used. Right Bracket Tabletop Safty Pins Safty Pins...
- Page 3 GAVI FOLDING WORKBENCH INSTALLATION INSTRUCTIONS TABLE HEIGHT ADJUSTMENT INSTRUCTIONS Storing Workbench To store the tabletop in the 42” Table Height: stored position, remove the Safety Pins and slide 1) To adjust the table height to 42”, start from the stored postion with the safety pins in place.
- Page 4 Disclaimer: The screws provided with the GAVI Folding Workbench are for wood stud installations only. Other applications may require different screws for proper and safe use. It is the buyer’s responsibility to research, secure and use the right ...
Need help?
Do you have a question about the Folding Workbench and is the answer not in the manual?
Questions and answers