TB142&150L(IM)out#4.11.09 11/10/09 10:39 AM Page 2 WHEN STARTING RE-BOIL C O N T E N T S Re-boil the hot water under the Keep warm mode. 1. To re-boil the water, push the REBOIL button. But Reboil before doing so it is important to first check the Button amount of water remaining in the pot.
TB142&150L(IM)out#4.11.09 11/10/09 10:39 AM Page 3 HOW TO USE IMPORTANT SAFEGUARDS CAUTION USING THE POT FOR THE FIRST TIME 1. Fill the pot to full level & boil water. • Do not embrace, tilt or shake the unit or carry by the 2.
Inlet Socket than 30cm. Water Level Gauge Panel Water Supply Indicator Revolving Bottom 360˚ • If the power cord is damaged, please contact the nearest authorised Morgan Service Centre to replace it. SPECIFICATIONS Outlet Socket Power Cord RATED VOLTAGE / FREQUENCY 220-240V, 50/60HZ •...
Page 5
TB142&150L(IM)out#4.11.09 11/10/09 10:39 AM Page 5 IMPORTANT SAFEGUARDS HOW TO USE Read all instructions BEFORE using 2 a) After connecting to the power supply, the power indicator light will be lit and WARNING the pot will begin boiling the water. b) Once the water is boiled, it automatically switch to “Keep Warm”...
TB142&150L(IM)out#4.11.09 11/10/09 10:39 AM Page 6 HOW TO CLEAN USING CITRIC ACID Ensure that the filter net has been installed to the inner container. Pour citric acid into the inner container. Dosage: about 20g for every litre of water. Add cold water to the 'full' mark and stir water thoroughly. Turn on the power immediately and heat until water is boiling then switch to keep warm.
Need help?
Do you have a question about the MTP-TB150L and is the answer not in the manual?
Questions and answers