Page 4
COBAN Technologies Patrol Car Installation Diagram COBAN Wireless Microphone System Operations 1. Locate the contacts at the bottom of the wireless mic. 2. Press the wireless microphone contacts directly on top of the receiver’s register contacts. NOTE: The receiver is located behind each of the front seats near nearest the door pillar. 3. A confirmation tone will sound to indicate the receiver and the microphone have synchronized their frequencies. 4. The wireless microphone is now on standby mode and ready for use. NOTE: Syncing a second microphone to the same receiver will replace and nullify the first microphone. Record button 4 ...
Page 5
COBAN Technologies The large button on the Microphone will always be used to initiate Status Indicators Recording (Default: Front only) Programmable Button Functions Toggle between Regular and Covert modes - hold Vibrates and beeps once Vibrates twice when down REC and Button 1 when active active 1. Mute – Toggle Audio Mute (does not affect Video) for two seconds 2. Stop – Stop Video (Not Recommended) Beeps and vibrates Twice...
Page 6
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.