POWERWINCH 825 Operation Manual

Anchor windlass

Advertisement

OPERATION MANUAL
S
*TNDLASS
| . L..t
r.-
.6r.d
I
MODEL 825
READ CAREFULLY EEFORE ATTEMPTING TO ASSEMBLE, INSTALL, OPERATE OR MAII,ITAIN THE
PBODUCT DESCRIBED. PROTECT YOURSELF AND OTHERS BY OBSERVING ALL SAFETY INFOBMA.
TION. FAILURE TO COMPLY WITH INSTRUCTIONS COULD RESULT IN PERSONAL INJURY AND/OR
PROPERW DAMAGE. RETAIN INSTRUCTIONS FOR FUTURE REFERENCE,
G e ne ral Saf ety (Conti n u ed )
Description
The model 825 anchor windlass retrieves and spools
any type of anchor. The uniquely designed rope and
chain windlass features a worm gear drive system for
fast power-up and power-down operalion and manual
free fall. This windlass is rated for a maximum working
load of 1 ,00O lbs.
UnPacking
When unpacking lhis product, carefully inspecl for any
damage that may have occurred during transit.
Ge ne ral Safety I nlormat i o n
The following safety precautions must be tollowed at all
lrmes:
1 . Read all manuals included with this product care'
fully. Be thoroughly familiar with the controls and
the prop€r use of the equipment. Only persons
well acquainted with these rules of safe operation
should be allowed to use the windlass.
Awnnnrnc
ALWAYS UNPLUG THE WIRING HARNESS TO
PREVENT ACCIDENTAL STABTING BEFORE AT.
TEMPTING TO INSTALL, SERVICE, RELOCATE OR
PERFORM ANY MAINTENANCE.
2. Never use the windhss to lift or move people or
animals-
3. Stand away from the windlass when in use and
keep children free from windlass area at all times-
4. Always keep hands clear of gypsy.
AWARNINGA
ALWAYS STAND CLEAR OF THE AREA BETU'EEN
THE LOAD OR ANCHOR POINT AND THE WIND-
LASS. SERIOUS INJURY COULD OCCUR, IF THE
ROPE BREAKS.
5. Do not wear loose fitting clothing, scarves, or neck
ties. Loose clothing may become caughl in moving
pans and resull in serious personal injury.
6. Alwayswirethewindlasswitha circuit breaker. Fail-
ure to use the breaker could cause overheating thus
creating a polential fire hazard or nrotor danuge.
CAUTION
When the windlass is not in use, the anchor must
be tie4off onto a cleat to relieye motor t€nsion
and prevent boat damage. Also, when trailering
the boat th€ anchor must be tied-off. Failurs to do
so invalidatos th€ warranty.
7. Inspeclthe entire rope forweak or worn condition or
kinking (short tighl twist or curl) betore each use.
8. When replacingthe rope, always usea Powerwinch
rope. The rope affects the perforrnance of the gypsy.
9. Never substitute cable for rope. Possible injury
c.ould occur.
10. Do not atiempl to pull a load greaier than the rated
load of the windlass.
1 1 . Do not operate the windlass under the influence of
drugs, alcohol, or medication.
Specitications
Model
Anchor
Typs
No Load Line
Line Speed
(FPM)
Line
Size
Voltage
(volt)
Circuit
Breaker
(Amps)
Unit Weight
0bs)
Gsar
Ratio
Any
Chain 5/16 or 3/8" P.C.'
Bope 1/2' or Y8"
' t 2
200
192:1
' P.C. - Proof Coil - See page 7 for details
Unit
Lenglh
Unit
Hoight
Unit
widrh
Approximate
Boat Siz6
Maximum
Working Load
15-3/4'
8"
11-114"
26' - 50'
1,O00 lbs.
Copyright 1994, Campbell Hausfeld/ Smtl Fetzer Company
P7062601AV 2194

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 825 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Table of Contents