Advertisement
Top mount cover lifter (CRS 20)
1
Top Mount Cover Lifter Operation
• Open cover and fold in half.
• You can also lift the cover by standing
outside the hot tub.
• Grab on to the bar with the foam grip and
pull upward and back.
• You can also enter the hot tub and push the
cover up from the center.
2
• To close the cover from inside the spa, pull
the cover back towards you until it is resting
on the sides of the spa. Get out of the
tub and fold the top half of the cover.
• Position the spa cover on the spa, making
sure that all four corners are properly
positioned and square on the spa.
• Do not use the Canadian Spa Company top
Mount Cover Lifter in high wind conditions.
Injury from the spa cover being blown over
and impacting the spa user can occur.
3
4
Advertisement
Table of Contents
Summary of Contents for Canadian Spa CRS 20
- Page 1 • Grab on to the bar with the foam grip and positioned and square on the spa. pull upward and back. • Do not use the Canadian Spa Company top • You can also enter the hot tub and push the Mount Cover Lifter in high wind conditions.
- Page 2 Top mount cover lifter instructions (CRS 20) M x 24 L x 12 DESCRIPTION DESCRIPTION A. Support arm I. 3/8”x 3” (9.5 x 76 mm.) Hex cap bolt B. Foam grip J. 3/8”(9.5 mm.) Nylon locknut C. Centre coupler K. 3/8”(9.5 mm.) Flat washer D.
- Page 3 Top mount cover lifter instructions (CRS 20) Figure 1. To assemble & install: 82” or 12” 203 or 305mm. Mounting Brackets to the appropriate sides of the spa: Option 1. By positioning the mounting brackets 8” (203 mm.) down from the top of the spa shell, approximately 9”...
- Page 4 T: + 9714 - 8815223 www.canadianspacompany.fr F: + 9714 - 8815224 www.canadianspacompany.co.uk Canadian Spa Company meets ISO 9001 Standards When you purchase a hot tub from Canadian Spa Company, the ISO 9001 certification assures world class excellence in manufacturing and customer service. 07/06/13...
Need help?
Do you have a question about the CRS 20 and is the answer not in the manual?
Questions and answers