Page 1
COLOR TELEVISION RECEIVER Chassis : KS1B(P) Model : CS21K9MLDC/DWP COLOR TELEVISION RECEIVER CONTENTS Precautions Specifications and IC Data Disassembly and Reassembly Alignment and Adjustment Troubleshooting Exploded View and Parts List Electrical Parts List Block Diagram Wiring Diagram Schematic Diagrams...
“VOLUME” keys ( Up or Down). The adjust- 6. Cancel the Adjustment Mode by re-pressing ment parameters are listed in the accompany- the “FACTORY” or “Power OFF” keys. ing table, and selected by pressing the CHAN- NEL keys ( Samsung Electronics...
Page 3
0 ~ 1 5 P e ak Whit e Limit t ing FIX (100%) 0 ~ 1 M at r ix USA FIX (Mono) Au t omat ic Gai n Cont r ol 0 ~ 6 3 (27) Samsung Electronics...
Page 4
AUDIO MUTE - Inital Language agter Factory Reset LANGUAGE ENGLISH - Hotel mode On/ Off HOTEL MODE - Bule Screen On/ Off without signal BULE SCREEN - SIF Option at Mono sound 2'nd SIF INTERNAL - V-CHIP On/Off V-CHIP Samsung Electronics...
7. Do not attempt to connect or disconnect any wires while the TV is turned on. Make sure that the power cord is disconnected before replacing any parts. 8. To protect against shock hazard, use an isola- tion transformer. Samsung Electronics...
Page 6
3. Use the P mode key (on the remote control) for the STANDARD picture. 4. Adjust the Screen VR (on the FBT) so that the voltage on the oscilloscope becomes 125+2.5V (See Fig. 4-1). 125 2.5V Fig. 4-1 Samsung Electronics...
Page 7
Mode with using CA100. See Fig. 4-4. Fig. 4-4 2. Adjust RG,BG so that the levels are suitable to each local area. (c) High-Light Adjustment 1. Set SCT to 35 FL in the Factory Service Mode with using CA100. See Fig. 4-4 . Samsung Electronics...
Page 8
8. Since the 4-pole magnets and 6-pole magnets lines in the center area of the screen. interact, the dot movement is complex (Fig. 4-5). RED/BLUE GREEN BLUE BLUE RED/BLUE GREEN 6-Pole Magnet Movement 4-Pole Magnet Movement Fig. 4-5 Center Convergence Adjustment Samsung Electronics...
Page 9
4. Fig. 4-7 4. Adjust with VSL (Vertical-Slope) so that the bottom margin of the picture is 4. Fig. 4-8 5. Adjust with HS (Horizontal Shift) so that the lion-head pattern and CRT centers are aligned. Samsung Electronics...
Page 10
IC201 S Abnormal Normal Check the 12.5V-A Line Check the (33)Pin (H-Drive) of IC201S Abnormal Abnormal Check/Replace IC802 Check the Normal FD802S, IC801S or AC-Fuse Abnormal Check the 130V- A Line Check the Normal FBT,D808 Check / Replace Q401 Samsung Electronics...