Psw1200 Input And Output Features And Use; Front Speaker Level In; Front Speaker Level Out - Polk Audio PSW1200 Owner's Manual

FIGURE 4.
VARIABLE
LOW PASS
CROSSOVER
40Hz 120Hz
VARIABLE
PHASE
ALIGNMENT
0 180
POWER
AUTO OFF ON
SWITCHABLE
HIGH PASS
CROSSOVER
(LINE LEVEL)
40HZ 80HZ
FRONT FRONT
LEFT RIGHT
OUT OUT
LEFT RIGHT
FRONT
FRONT
IN IN
LEFT RIGHT
REAR
REAR
IN IN
CENTER 1 CENTER 2
IN IN
LFE/SUBWOOFER IN
bottom end of the Rear speakers at
40Hz. Simply use either the Front Line
Level or Front Speaker Level in/out sets
to do that (assuming they are not
already in use). Be creative.
PSW1200 INPUT AND OUTPUT
FEATURES AND USE
Front Speaker Level In–Although these
are labeled "Front," they can be used
for any channel. If your equipment does

FRONT SPEAKER LEVEL OUT

L R
+
–
40HZ
SWITCHABLE
HIGH PASS
80HZ
CROSSOVER
(SPEAKER LEVEL)
FULL RANGE
–
+
L R

FRONT SPEAKER LEVEL IN

+
–
80 HZ
FULL RANGE
not have—or if you do not wish to use—
preamp level outputs to drive your
Subwoofer, you can deliver signal via
speaker wire (Fig. 4). The signal will pass
through the Variable Low Pass Crossover.
FRONT SPEAKER LEVEL OUT–
These may be used to route signal to
speakers, especially if you want the
PSW1200 to filter bass frequencies out
of those speakers. (Fig. 4)
40 HZ
9