Advertisement
Quick Links
Contents of kit
1. GPS Module
Contents of box:
2. ODB II wire harness
1. GPS Module
3. Gap Panel switch
2. OBDII wire harness
4. 8- 5" zip ties
3. Gap Panel switch
5. 2- 15" zip ties
4. Zip ties
6. 2- Double sided tape for
5. Double sided tape
Wrangler installation only
6. Window Sticker
7. Window sticker
7. EVTS Owner's Manual
8. EVTS Owner's Manual
9. 2- Alcohol pads
10. Adhesion promoter
5
8
Visit www.moparevts.com
information is required to view the specific installation locations. For additional information contact Guidepoint Technical
Support at 1.877.477.3710
IMPORTANT: Make sure to get the ESN from the label on the module or from the box. You should also place
the extra ESN label sticker in the front cover of the EVTS owner's manual. Be sure to provide the ESN to the
customer so that they can easily activate their new EVTS system.
WARNING: Make sure to keep GPS Module and wiring harness away from AIRBAGS, AIRBAG WIRING, and
any moving objects under the dash. (i.e. steering joints, brake pedal and shift levers.)
This information is provided to assist with installation of certain features available on the EVTS device and
may contain outdated or incorrect information. It is the technician's job to verify all wires being used and
connect them properly. Guidepoint is not responsible for any damage that may occur due to improper testing
and/or installation of components related to this installation supplement. If you feel that the information
contained in this supplement is incorrect, please contact Guidepoint Technical Support at 1.877.477.3710.
For instructions related to trim panel, instrument cluster and radio removal
NOTE: THE FIAT 124 SPIDER WILL REQUIRE AN ADDITIONAL INSTALL KIT DUE TO THE MOUNTING LOCATION
July 20, 2016
Electronic Vehicle Tracking System
Technical Support 877-477-3710
1
4
and login using the EVTS dealer login
NOTE: FIAT 124 SPIDER WILL REQUIRE AN ADDITIONAL INSTALL KIT
refer to the vehicle specific service manual.
(EVTS)
2
Double sided tape used only for
Wrangler installation.
6
10
9
for vehicle specific mounting locations. Dealer log in
1
www.moparevts.com
3
7
K6861090AB
Advertisement
Related Manuals for Mopar EVTS
Summary of Contents for Mopar EVTS
- Page 1 IMPORTANT: Make sure to get the ESN from the label on the module or from the box. You should also place the extra ESN label sticker in the front cover of the EVTS owner's manual. Be sure to provide the ESN to the customer so that they can easily activate their new EVTS system.
-
Page 2: Installation Instructions
Installation Instructions Technical Support 877-477-3710 www.moparevts.com Disconnect Battery Negative Terminal Find a suitable location for the Control Module The module should be underneath the dash and not Disconnect the negative terminal of the vehicle's visible. There should not be any metal obstructing battery. - Page 3 Installation Instructions Technical Support 877-477-3710 www.moparevts.com Install the Guidepoint Access Panel Reconnect Battery Negative Terminal Warning: Make sure that you have not left any The Guidepoint Access Panel (GAP) is required and plugs unplugged for this may set off the check will provide additional features and functionality for engine light.
- Page 4 Unit Testing Protocol & Best Practices Technical Support 877-477-3710 www.moparevts.com Install Window Sticker Apply Window Sticker to the lower rear of the driver's side window. It should be visible from the outside of the vehicle. L.E.D. Pattern L.E.D. Description Green LED not flashing The ignition has not been turned on Green LED off for 1 second GPS module has power and signal is valid, Cell modem is powered, ignition is ON...
Need help?
Do you have a question about the EVTS and is the answer not in the manual?
Questions and answers