Advertisement
I. Function of Auto On-Off (Power saving mode)
Note: Power saving mode would not function when log is enabled.
BT-Q1200 supports Auto On-Off (Power saving mode). It can automatically enter
sleeping mode after the Bluetooth connectivity is turned off, so the Blue LED will turn
to flash every 5 seconds. Thus you can always power it on with very low power
consumption.
Under power saving mode, when detecting Bluetooth is being connected, BT-Q1200
will auto wake up itself and the blue LED will turn to flash every 2 seconds and GPS
Orange LED will be also On.
J. OTHERS
J-1 LED Indicators
LED Status
1
Power (Red/Green)
2
Bluetooth (Blue)
3
GPS (Orange/Blue)
4
Log (Blue)
J-2 GPS Features
1. Baud Rate: 115,200 bps / Datum: WGS-84; Hot/Warm/Cold Start: 1/33/36 sec.
(averaged)
2. 51-channel Bluetooth GPS Receiver with super high sensitivity at -158dBm
3. Bluetooth Version: V1.2 / SPP profile / Class 2 with 15 meters in open space
4. Low power consumption, built-in rechargeable Lithium battery (up to 48 hrs after
fully charged with sufficient)
BT-Q1200 Super 99
Flash
Low Power (Red)
Fully charged
(Green)
Flash per 2 sec.:
Bluetooth connected
Flash per 5 sec.:
Power saving mode
Flash per 1
sec.(Orange): GPS
position is fixed,
Navigation
Flash 3 times (Blue):
POI(Point of
Interest) is recorded
Travel Logging is on
®
GPS Travel Recorder
ON
Recharging
(Green)
Not
GPS not
connected /
powered
Pairing
Detecting
Satellite,
GPS not
GPS
powered
position not
fix
Logging
OFF
Travel
is off
6
Advertisement
