Summary of Contents for Heliotrope PV RV-45D
- Page 1 OPERATION MANUAL for the RV-45D Solar Charge Controller Manufactured by: Heliotrope PV Eugene, OR 541-284-2426 phone 541-284-2427 fax...
-
Page 2: System Overview
Solar Module the least amount of battery water consumption. HELIOTROPE RV-45D Manufactured by Heliotrope PV Eugene, OR 2) Selectable State-of-Charge Set from 13.2 VDC to 14.6VDC in 0.2 volt increments. 3) Selectable “Auto-Equalize”, “Auto-Float” or “Fixed” “Equalize” for Flooded Lead-Acid Batteries, “Float”... - Page 3 It is literally two charge controllers in one, and as such, the RV-45D allocates the charge to both the house and the en- gine batteries. The “Engine” battery charging circuit is limited to 3 amps with a state-of-charge voltage fixed at 13.4 VDC.
-
Page 5: Automatic Equalization
As the sun rises, (and the solar panels reach a voltage the off position. This locks the SOC voltage setpoint to wherever that is slightly higher than the battery voltage), the RV-45D will you set it . deliver all available charging amperage to the batteries. The... -
Page 6: Warranty
The battery voltage will rise under this influence until it approaches whatever SOC voltage setpoint you have selected. At this point, the RV-45D will enter its Pulse Width Modulation “Taper” charge and deliver whatever charging amperage the battery requires to maintain the selected SOC voltage setpoint.